Pioneer XY series Installation Manual page 24

3 Rigging And Caster Setting
__________________________________________________________________________________________________________
Part list (CP-XY12HC1/CP-XY15HC1)
Item Part Name
A Horizontal Flying Cradle
Main Yoke
Mounting Plate
Neoprene Washer
Flat Washer
Spring Washer
Lever
B M10 socket head bolt
C Spring Washer
D Flat washer
Procedure
Note: The yoke length can be changed by unscrewing the lever and
choosing mounting holes in the both plate ends of the Horizontal Flying
Cradle.
(1) Remove the four pre-inserted mounting screws on the top and the
bottom of XY-81/101/122/152. (XY-81/101/122: Fig.3-2-2-A), (XY-152:
Fig.3-2-2-B)
XY-122/101/122
Fig.3-2-2-A
(2) Using the supplied 4 bolts(B), align the mounting holes in the end
mounts of the plate of the horizontal Flying Cradle(A) with the
mounting points on the top and the bottom of the enclosure. The
installation method depends on the model you use. Please follow the
steps below for further details when installing such a model.
XY-81/101:
Using the supplied M8 countersunk bolts(B), align the mounting holes
in the end mounts of the plate of the Horizontal Flying Cradle(A) with
the mounting points on the top and the bottom of the enclosure.
Tighten the bolts over 7N·m torque. (Fig.3-2-2-C)
XY-122:
Using the supplied M10 hex socket head bolts(B), align the mounting
holes in the end mounts of the plate of the Horizontal Flying Cradle(A)
with the mounting points on the top and the bottom of the enclosure.
Ensure that both Spring Washer(C) and Flat washer(D) are used - the
Flat Washer(D) should be in contact with the cradle. Tighten the bolts
over 15N·m torque. (Fig.3-2-2-C)
Qty Service Part No. Note
1 -
1 -
2 -
2 05B010 40mm x 2mm
2 06D014 M10
2 06D015 M10
2 05A103 M10
M10 x 40mm (P=1.5),
5 06G053
8mm hex socket head
5 06D015 M10
5 06D014 M10
Required tools
・screwdriver
・8mm hex key
XY-152
Fig.3-2-2-B
NOTE: XY-122 is shown in the illustration.
(D)
Fig.3-2-2-C
(A)
(C)
(B)