Pioneer XY series Installation Manual page 20

3 Rigging And Caster Setting
_________________________________________________________________________________________________________
Procedure (CP-XY8VC1/XY10VC1/XY12VC1/XY15VC1)
(1) Remove the pre-inserted mounting screws from the top of enclosure.
The number of screws to be removed from XY-81/101/122 is 2 (The
location is shown in Fig.3-2-1-A) and from XY-152 is 4.
Only XY-152
NOTE: In addition, Using the supplied two M10 socket head bolts(E),
align the mounting holes in the load plate(F) with the mounting point on
the top of the enclosure. Tighten the bolts over 15N·m torque. (Fig.3-2-
1-B)
(2) Using the supplied two bolts(B), align the mounting holes in the inner
yoke of the Vertical Flying Cradle(A) with the mounting points on the top
of the enclosure. The installation method depends on the model you
use. Please follow the steps below for further details when installing
such a model. (Fig.3-2-1-C)
XY-81:
Using the supplied two M8 countersunk bolts(B), align the mounting
holes in the inner yoke of the Vertical Flying Cradle(A) with the
mounting points on the top of the enclosure. Tighten the bolts over 7N·
m torque.
XY-101/122/152:
Using the two socket head bolts(B), align the mounting holes in the inner
yoke of the Vertical Flying Cradle(A) with the mounting points on the top
of the enclosure. (Fig.3-2-1-C)
WARNING: The Vertical Flying Cradles should be installed to the XY-
122/152 enclosure in a specific orientation. Please see Fig.3-2-1-D to
install the Vertical Flying Cradle to the enclosure in the correct
orientation.
FRONT
XY-122
Ensure that both the Flat Washer(D) and the Spring Washer(C) are used -
the Flat Washer(D) should be in contact with the cradle. Tighten the
bolts over 15N·m torque (Only XY-101: 7N·m torque). (Fig.3-2-1-C)
(E)
(F)
(C)
(D)
Fig.3-2-1-B
FRONT
XY-152
Fig.3-2-1-D
NOTE: XY-122 is shown in the illustrations below.
Fig.3-2-1-A
(A)
Fig.3-2-1-C
(B)
(C)
(D)
Only XY-152
(B)
(C)
(D)
φ13
Fig.3-2-1-E