Pioneer XY series Installation Manual page 25

3 Rigging And Caster Setting
__________________________________________________________________________________________________________
XY-152:
Using the supplied M10 hex socket head bolts(B), align the mounting
holes in the end mounts of the plate of the Horizontal Flying Cradle(A)
with the mounting points on the top and the bottom of the enclosure.
WARNING: The mounting plate of Horizontal Flying
Cradle should be installed to the XY-152 enclosure in a
specific orientation. Please see Fig.3-2-2-D to install the
Horizontal Flying Cradle in the correct orientation.
Ensure that both Spring Washer(C) and Flat washer(D) are used - the
Flat Washer(D) should be in contact with the cradle. Tighten the bolts
over 15N·m torque. (Fig.3-2-2-C)
(3) Once the desired angle of the loudspeaker is set, tighten the
knobs/levers on the cradle to lock the position in place. (Fig.3-2-2-E)
(4) The holes on the top of the horizontal Flying Cradle(A) can be used to
install the speaker to the ceiling or the wall in the horizontal position.
(Fig.3-2-2-E)
(5) Remove the two mounting screws pre-inserted in the holes on the rear
side of enclosure.
(6) Ensure the two commercially-available eyebolts are secured to the rear
points on the enclosure to suspend it with wire as a secondary safety
feature. (Fig.3-2-2-F)
SHORT
SIDE
FRONT
φ13 X 3
Fig.3-2-2-E
NOTE: XY-122 is shown in the illustration.
Fig.3-2-2-F
NOTE: XY-122 is shown in the illustration.
LONG
SIDE
BACK
Fig.3-2-2-D
Commercially
-available
eyebolt