Pioneer XY series Installation Manual page 28

3 Rigging And Caster Setting
__________________________________________________________________________________________________________
Procedure
(1) Remove the two pre-inserted mounting screws on the top of
enclosure. (Fig.3-2-3-B)
(2)
Using the supplied M10 hex head bolts(D), align the mounting holes in
the Variable angle bracket(A) with the mounting points on the top of
the enclosure.
WARNING: Please look carefully at the illustration below before
installing the Variable Angle Bracket to the enclosure and place the
Variable Angle Bracket in the right position to align its front and the top
front of the enclosure.
CP-XY12AB1
Front
CP-XY15AB1
3pcs
Wide
Front
NOTE: A product label is stuck on the front of the
Ensure that both the Spring washers(E) and Flat washers(F) are used -
the Flat washer(F) should be in contact with the bracket. Tighten the
bolts over 15N·m torque. (Fig.3-2-3-C)
(3) Using the socket head bolt(C) and the Nut(G), attach the hook-
clamp(B) to the mounting point. Moving the pickup point to the rear of
the enclosure will add down-tilt, and moving to the front of the
enclosure will apply up-tilt. Ensure that two Flat Washers (F) are used
between the Hook-clamp(B) and M10 socket head bolt(C) as well as
the nut(G) and the hook-clamp(B). (Fig.3-2-3-D)
Note: For larger down-tilt angles, position the pivot on the last hole
and use the point on the rear or underside as a pull-back.
The hole (φ13) on the hook-clamp(B) can be used to install the speaker
(4)
to the ceiling. (Fig.3-2-3-D)
angle bracket.
NOTE: XY-122 is shown in the illustration.
Back
2pcs
Narrow
Back
(D)
(E)
(F)
Fig.3-2-3-B
(A)
Fig.3-2-3-C
(B)
(G)
(C)
(F)
(F)
Fig.3-2-3-D