LawnMaster CLGT4012K Operator's Manual page 13

OPERATION
Trimming
• Attach the trimming head to cut smaller
types of weed, lawn grass or similar soft
vegetation.
• Hold the product firmly with a gap between
the product and your right side.
• Stand upright, do not lean forward and
pay attention to posture. Keep both feet
apart to help retain your balance.
• Hold the trimming head just above the
ground at an angle of approximately 30°
(Fig. 11). Avoid pressing it against the
ground as this can ruin the lawn and damage the product.
• Move the product with a slow regular arc from left to right before moving it back to the starting
position and trimming the next area (Fig. 12).
WA RN IN G
To avoid hazards, remove the battery pack when the user wants to transport the product in
another area to prevent a random start. Failure to heed this warning could result in serious
personal injury.
• Ensure the cutting device remains clean and free from off-cuts that may cause it to jam. Check
regularly. Release the on/off switch and remove the battery pack before checking.
• Trim longer grass in stages; do not cut long grass in one cut (Fig. 13). For the best results, cut
longer grass in steps (Fig. 14).
• Wait until the product has come to a standstill before placing it down.
Tips
• For best results, do not cut wet grass because it tends to stick to the trimming head and guard,
prevents proper discharge of grass trimmings, and could cause you to slip and fall.
30°
Fig. 11
Fig. 13
13
Fig. 12
Fig. 14