Miles Industries RETROFIRE RF24XBN Installation And Owner's Manual

Hide thumbs Also See for RETROFIRE RF24XBN:

Advertisement

Quick Links

RF24XBN (NG) & RF24XBP (LPG)
DANGER
!
A barrier designed to reduce the risk of burns from the hot
viewing glass is provided with this appliance and shall be
installed for the protection of children and other at-risk
individuals.
!
WARNING
FIRE OR EXPLOSION HAZARD
Failure to follow safety warnings exactly
could result in serious injury, death, or
property damage.
— Do not store or use gasoline or other
fl ammable vapors and liquids in the
vicinity of this or any other appliance.
— WHAT TO DO IF YOU SMELL GAS
▪ Do not try to light any appliance.
▪ Do not touch any electrical switch; do
not use any phone in your building.
▪ Leave the building immediately.
▪ Immediately call your gas supplier from
a neighbor's phone. Follow the gas
supplier's instructions.
▪ If you cannot reach your gas supplier,
call the fi re department.
— Installation and service must be
performed by a qualifi ed installer, service
agency or the gas supplier.
4002862-11
© 2014 Miles Industries Ltd. All rights reserved.
R
ETROFIRE
Gravity Vent Fireplace Insert
Installation and Owner's Manual
HOT GLASS WILL
CAUSE BURNS.
DO NOT TOUCH GLASS
UNTIL COOLED.
NEVER ALLOW CHILDREN
TO TOUCH GLASS.
L e a v e t h i s m a n u a l
w i t h t h e a p p l i a n c e .
R e t a i n t h i s m a n u a l
f o r f u t u r e r e f e r e n c e .
Please read this manual
BEFORE installing and
operating this appliance.
This appliance may be installed in an
after-market permanently located,
manufactured (mobile) home where not
prohibited by local codes.
This appliance is only for use with the type
of gas indicated on the rating plate. This
appliance is not convertible for use with
other gases, unless a certifi ed kit is used.
This appliance is a domestic room-heating
appliance. It must not be used for any other
purposes such as drying clothes, etc.
This appliance is suitable for installation in a
bedroom or bed sitting room.
Massachusetts: The piping and fi nal
gas connection must be performed by a
licensed plumber or gas fi tter in the State of
Massachusetts.
Ce guide est disponible en français sur demande.
US Patent no. 8,166,965
I N S TA L L E R
C O N S U M E R

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the RETROFIRE RF24XBN and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for Miles Industries RETROFIRE RF24XBN

  • Page 1 fi re department. Ce guide est disponible en français sur demande. — Installation and service must be performed by a qualifi ed installer, service agency or the gas supplier. 4002862-11 © 2014 Miles Industries Ltd. All rights reserved.
  • Page 2: Table Of Contents

    Spare Parts............28 The information contained in this installation manual is believed to be correct at the time of printing. Miles Industries Ltd. reserves the right to change or modify any information or speci- fi cations without notice. Miles Industries Ltd.
  • Page 3: Safety Precautions

    Safety Precautions READ and UNDERSTAND all instructions carefully Due to the high temperature, the appliance should be before starting the installation. FAILURE TO FOLLOW LOCATED out of traffi c areas and away from furniture these installation instructions may result in possible fi re and draperies.
  • Page 4: Safety And Your Fireplace

    Safety and Your Fireplace Safety and Your Fireplace Please Read and Carefully Follow all Safety Warnings and Operating Instructions Contained in Your Owner’s Manual (Replacement Manuals are available by contacting our service department at 1-800-468-2567 or visit www.valorfi replaces.com). skills and response refl exes to Please Follow These Important withdraw in the event of accidental Child Safety Precautions and...
  • Page 5: Owner's Information

    Owner’s Information INFORMATION Thank You ... WARNING For purchasing a Valor by Miles Industries. Your new EXTREMELY HOT!!! radiant gas heater is a technical appliance that must be installed by a qualifi ed dealer. Each Valor fi replace • READ the SAFETY information on pages...
  • Page 6: Cleaning Your Fireplace

    The following recommendations will not guarantee results in your particular case. NOTE: This is a problem beyond Miles Industries’ control and is not covered under warranty. • Clean the glass regularly as soon as you notice the buildup (white fi...
  • Page 7: Checking Pilot And Burner Flames

    OWNER’S Owner’s Information INFORMATION a. Hook the window over the top b. Push the top of the screen against the top of the edge of the fi rebox, and window frame and while holding it bend the top fasten the bottom two brackets around the window frame to secure the spring- loaded bolts screen.
  • Page 8: Replacing Batteries

    Should the safety switch require replacement, only Servicing Your Fireplace use parts supplied by Miles Industries. If any attention is required for your appliance, contact your supplier quoting the model number. It will be helpful if the appliance’s serial number can also be...
  • Page 9: Remote Control Operation

    OWNER’S Remote Control Operation INFORMATION Your fi replace remote control helps you get the comfort, convenience and aesthetics you want from your gas fi replace. The remote controls your fi replace in different ways. IMPORTANT: BEFORE YOU BEGIN, please note that on this system, the settings of time, temperature and automatic ON/OFF can only be programmed when the function display is fl...
  • Page 10: Battery Replacement

    OWNER’S Remote Control Operation INFORMATION Programming time and temperature You can set your fi replace to come on before you wake up and turn off after you leave and then, turn on again just before you come home and turn off after going to bed. You can leave it like this for the heating season.
  • Page 11: Options

    OWNER’S Options INFORMATION Required Accessories* Screened Fronts (with RA24ZC only) RA24DS—Draw Screen Venting RA24FS—Fixed Screen Pipe—Generic 3” dia. fl exible aluminum liner approved 743FVI—FenderFire Double Door for gas venting into existing fi replace and chimneys or 744FVI—FenderFire Single Door 4” dia. type “B” vent with zero clearance kit option. 555CFK—Circulating Fan Kit, thermally actuated, variable speed, 6’...
  • Page 12: For Your Safety Read Before Lighting

    OWNER’S Lighting Instructions INFORMATION FOR YOUR SAFETY READ BEFORE LIGHTING WARNING: If you do not follow these instructions exactly, a fire or explosion may result causing property damage, personal injury or loss of life. A. This appliance has a pilot, which must be lighted by hand. When lighting the pilot, follow these instructions exactly.
  • Page 13: Specifi Cations

    QUALIFIED Specifi cations INSTALLER *High Altitude Installations This appliance is intended for installation into existing masonry or factory-built, solid-fuel burning Input ratings are shown in BTU per hour and are fi replaces only. certifi ed without deration for elevations up to 4,500 feet (1,370 m) above sea level.
  • Page 14: Dimensions

    QUALIFIED Dimensions INSTALLER Dimensions— for Solid-Fuel Burning Fireplace Insert Only See separate framing Dimensions for Zero Clearance applications with the Zero Clearance Kit RA24ZC. 17” 24-1/2” 24-3/8” Stand-offs 8” 7-5/8” 3” dia. Collar 1225VFB Ventana Fret (Black) RA24TB Fret (Black) 25-1/2”...
  • Page 15: Vent Confi Gurations

    QUALIFIED Dimensions INSTALLER Mantel / Hearth Clearances Combustible Mantel and Hearth Clearances for insert NOTE: The glass front and hearth are very hot. Existing applications must conform to those required for the wire mesh screens or free standing hearth mounted original solid-fuel burning fi...
  • Page 16: Existing Fireplace Preparation

    QUALIFIED Existing Fireplace Preparation INSTALLER Gas Line Routing A few points must be considered before inserting the RF24 into an existing fi replace cavity. Generally, Plan the routing of the gas line before proceeding. modifi cations to the existing fi replace that will compro- Utilize the existing hole for the gas line.
  • Page 17: Installation

    QUALIFIED Installation INSTALLER Connect Gas Supply • Make sure that the appliance is turned off. • Open the manual shut-off valve. • It’s preferable to rough-in the gas line at this point • Test for leaks by applying a liquid detergent before proceeding with the fi...
  • Page 18: Rough-In Vent Liner

    QUALIFIED Installation INSTALLER Rough-in Vent Liner When connecting the liner in this manner, it is best to leave the top termination until later so the slack liner Rough-in the 3” diameter vent liner into existing can be lifted after the insert is in place. chimney system being careful not to tear or damage the liner in the process.
  • Page 19: Connect Vent Liner To Appliance

    QUALIFIED Installation INSTALLER Connect Vent LIner to Appliance Trim Liner and Connect The vent plate will ultimately locate approximately 19” Vent Plate to Liner using Gear Clamp provided above the base of the fi replace once inserted. 1. Trim the liner accordingly so it will not be too long Approx.
  • Page 20: Level Appliance In Hearth

    QUALIFIED Installation INSTALLER Level Appliance in Hearth The backside of each support leg has a leveling bolt. If necessary, adjust the level of the fi rebox in the hearth. Fret bracket Leveling Leveling Front Back bolt Leveling bolt bolt Front View Side View Re-install Burner Module Note: If the circulating fan is to be installed it...
  • Page 21: Install Top Convection Baffl E

    QUALIFIED Installation INSTALLER Install Top Convection Baffl e Position the fi rebox as far back as possible within the existing fi replace to allow ample space at front for the fret and to allow convection air to fl ow under the smoke curtain of the existing fi...
  • Page 22: Install Ceramic Log Set

    QUALIFIED Installation INSTALLER Install Ceramic Log Set position depending of the gas type. The position of the logs is critical to insure the Carefully remove the ceramic logs from the packaging good performance of the appliance. taking care not to damage them. Install the logs as described below.
  • Page 23: Refi T Window

    QUALIFIED Installation INSTALLER Refi t Window Hook the window over the top edge of the fi rebox, and fasten the bottom two spring loaded bolts by pushing in and turning 90 degrees. If the Hot Glass Warning plate has been removed from the front lower corner of the window, reinstall it by sliding it between the glass and the frame as indicated.
  • Page 24: Check Operation

    QUALIFIED Installation INSTALLER Check Operation Turn the fi replace up and down using the remote control to confi rm Air Shutter that the full range of inputs is achieved. Adjust Aeration (if necessary) Light the fi re and allow to warm up for 10–15 minutes to evaluate the fl...
  • Page 25: Install Barrier Screen

    QUALIFIED Installation INSTALLER Install Barrier Screen A barrier screen is supplied with this appliance to install on the Retrofi re window. The barrier screen is designed specifi cally to prevent any contact with the glass of the fi replace which becomes hot during operation and remains hot when cooling.
  • Page 26: Install Cast Iron Fret Or Bottom Cover

    QUALIFIED Installation INSTALLER Install Cast Iron Fret or Bottom Cover Fret Brackets Installation Cast Iron Fret Installation 1. Screw 2 thumbscrews into each retainer tab. 1. Adjust the screw heads on the back of fret to the 2. Fit the retainer tabs to each leg (1 screw per side). thickness of the fret bracket.
  • Page 27: Warranty

    1. Extended Warranty Coverage For a period of up to ten (10) years, Miles Industries Ltd., (the “Company”) or its appointed distributor will at its option pay the initial purchaser for the repair of, or will exchange the following parts or components which are found to be defective in material or...
  • Page 28: Spare Parts

    OWNER’S Spare Parts INFORMATION PART PART DESCRIPTION DESCRIPTION NUMBER NUMBER Firebox Assembly 4000634AH 2-Flame Pilot Hood 4000730 Vent Plate 4001010 Electrode 720A543 Convection Baffl e 4001009 Pilot Tube 4000732 LH Fret Support 4003652BY GV34 Complete Valve NG 4003103 LH Retainer Tab 4003650 GV34 Complete Valve LPG 4003116...
  • Page 29 OWNER’S Spare Parts INFORMATION 39a, 39b...
  • Page 31 Serial Number: Date Purchase (yyyy-mm-dd): Dealer: Customer Information First Name: Last Name: Contact Information Email: Mailing Address Address: City: Province/State: Postal/Zip Code: Country: Cut out page, fi ll information, and mail to Miles Industries Ltd. Online Warranty registration at www.valorfi replaces.com...
  • Page 32 Tape Shut Fold here Postage needed Miles Industries Ltd. 190 - 2255 Dollarton Highway North Vancouver, BC V7H 3B1 Canada Online Warranty registration at www.valorfi replaces.com Thank you for choosing a Valor Product...

Table of Contents