Table of Contents
Advertisement
Quick Links
738BXN (NG) & 738BXP (LPG)
WARNING: If the information in these
instructions is not followed exactly, a fi re
or explosion may result causing property
damage, personal injury or loss of life.
Do not store or use gasoline or other
fl ammable vapors and liquids in the vicinity
of this or any other appliance.
WHAT TO DO IF YOU SMELL GAS
• Do not try to light the appliance.
• Do not touch any electrical switch; do not
use any phone in your building.
• Immediately call your gas supplier from
a neighbor's phone. Follow the gas
supplier's instructions.
• If you cannot reach your gas supplier, call
the fi re department.
Installation and service must be performed
by a qualifi ed installer, service agency or the
gas supplier.
4001379-08
©2011, Miles Industries Ltd.
L
EGEND
Gravity Vent Gas Insert
Installation & Owner's Manual
HOT GLASS WILL
CAUSE BURNS.
DO NOT TOUCH GLASS
UNTIL COOLED.
NEVER ALLOW CHILDREN
TO TOUCH GLASS.
Manufactured by
MILES INDUSTRIES LTD., British Columbia, Canada
www.valorfi replaces.com
I NSTALLE R
Lea ve t his ma nua l
with t he applianc e.
C ON SU MER
Re tain t his manua l
for f uture ref e re nce.
Please read this manual BEFORE installing
and operating this appliance.
This appliance may be installed in an after-
market permanently located, manufactured
(mobile) home where not prohibited by local
codes.
This appliance is only for use with the type
of gas indicated on the rating plate. This
appliance is not convertible for use with
other gases, unless a certifi ed kit is used.
This appliance is a domestic room-heating
appliance. It must not be used for any other
purposes such as drying clothes, etc.
This appliance is suitable for installation in a
bedroom or bed sitting room.
Massachusetts: The piping and fi nal gas
connection must be performed by a licensed
plumber or gas fi tter in the State of Massa-
chusetts.
Ce guide est disponible en français sur demande.
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for Miles Industries LEGEND 738BXN NG
Summary of Contents for Miles Industries LEGEND 738BXN NG
- Page 1 fi tter in the State of Massa- by a qualifi ed installer, service agency or the chusetts. gas supplier. Ce guide est disponible en français sur demande. Manufactured by MILES INDUSTRIES LTD., British Columbia, Canada www.valorfi replaces.com 4001379-08 ©2011, Miles Industries Ltd.
-
Page 2: The Fireplace
Thank You ... For purchasing a Valor by Miles Industries. Your new radiant gas heater is a technical appliance that must be installed by a qualifi ed dealer. Each Valor fi replace is fully tested during the production process for your safety and comfort. -
Page 3: Safety And Your Fireplace
Safety and Your Fireplace Safety and Your Fireplace Please Read and Carefully Follow all Safety Warnings and Operating Instructions Contained in Your Owners Manual (Replacement Manuals are available by contacting our service department at 1-800-468-2567 or visit www.valorfi replaces.com). withdraw in the event of accidental Please Follow These Important contact with a hot surface. -
Page 4: Table Of Contents
Table of Content Safety and Your Fireplace ................3 Safety and Warning Information..............5 Specifi cations ....................6 ◊ Overview ......................7 Dimensions ....................8 Cavity ......................8 ◊ Clearances ......................9 Venting ......................10 Installation Planning ..................11 Existing Fireplace Preparation ..............11 Appliance Preparation .................12 Supply Gas ....................14 Ignition Spark Check ...................15 Remote Control Preparation ...............16 Ceramic Bricks .....................17... -
Page 5: Safety And Warning Information
Safety and Warning Information OWNER’S INFO READ and UNDERSTAND all instructions carefully This unit MUST be used with a vent system as before starting the installation. FAILURE TO FOLLOW described in this installation manual. NO OTHER vent these installation instructions may result in possible fi re system or components MAY BE USED. -
Page 6: Specifi Cations
Safety and Warning Information OWNER’S INFO Operating your fi replace for the fi rst time It is also possible that these vapors could set off any smoke detection alarms in the immediate vicinity. When operating your new fi replace for the fi rst time, These vapors are quite normal on new appliances. -
Page 7: Overview
Overview INSTALLATION This appliance, as supplied, may ONLY be installed in an existing unaltered, functioning solid-fuel burning fi replace with a working fl ue and constructed of non-combustible material. This appliance is APPROVED for installation into combustible type construction only when using the 770ZCK Zero Clearance Kit (see separate instructions packaged with the kit for details). -
Page 8: Dimensions
Dimensions INSTALLATION 28-5/8” (727 mm) 19-1/2” (495 mm) 12” (305 mm) or 12-5/8” (321 mm) Varies with outer trim options Optional Outer Trim or Surround sold separately 7-7/8” (200 mm) or 8-1/2” (216 mm) Varies with outer trim options 20” (508 mm) Gas inlet Gas connection... -
Page 9: Clearances
Clearances INSTALLATION WARNING Some materials or items, although safe, may discolor, shrink, warp, crack, peel, Some materials or items, although safe, may discolor, shrink, warp, crack, peel, and so on because of the heat produced by the fi replace. Avoid placing candles, and so on because of the heat produced by the fi... -
Page 10: Venting
Venting INSTALLATION Vent Location Typical Vent Installation The vent terminal must be located through the roof. This gravity vent appliance is designed to opreate when an undistrubed Terminal Cap airfl ow hits the outside vent terminal from any direction. Check local codes for allowable vertical vent termination. Flashing Vent Materials Use a 3”... -
Page 11: Installation Planning
Installation Planning INSTALLATION Installer—READ THIS FIRST 13. Install the remote control handset wall holder. 1. YOU NEED TO KNOW FROM THE HOMEOWNER what accessories (surround, 14. Instruct the homeowner on the operation and door, etc.) will be installed with this fi replace; maintenance of the fi... -
Page 12: Appliance Preparation
Existing Fireplace Preparation INSTALLATION Existing Glass Doors and Wire Screens Attach Warning Conversion Plate to Existing Fireplace (label supplied loose with 738BX Existing glass doors must be permanently removed heater) prior to installing the 738BX insert. Attach the “This fi replace has been converted...” Combustible Mantels label to the existing fi... -
Page 13: Venting Installation
Appliance Preparation INSTALLATION Venting Installation IMPORTANT: This appliance’s venting system requires room air to be used in the combustion process. 1. Rough-in one 3” diameter vent liner into the existing chimney system from the roof. Be careful not to tear or damage the liner in the process. -
Page 14: Supply Gas
Supply Gas INSTALLATION Pressure Test Points The gas supply inlet connection is a 3/8” NPT female connector and is located on the left hand side of the The minimum supply pressure is given in the section control valve. Specifi cations of this manual—page 6. All piping and connections must be tested for leaks after installation or servicing. -
Page 15: Ignition Spark Check
Ignition Spark Check INSTALLATION The pilot burner and electrode unit are at the left end of the burner. Push in the lighting knob and turn it counter-clockwise through the “IGN” position to “PILOT”. A spark should fl ash across from the pilot electrode to the pilot burner shield as shown below. Thermostat Knob Gas Control Knob... -
Page 16: Remote Control Preparation
Remote Control Preparation INSTALLATION CAUTION CAUTION DO NOT PUT BATTERIES IN THE REMOTE DO NOT USE a screwdriver or other metallic object to remove the batteries from the receiver or the CONTROL RECEIVER until the wires are handset! This could cause a short circuit to the connected to the burner control unit as short- receiver. -
Page 17: Ceramic Bricks
Ceramic Bricks INSTALLATION The following guidelines apply for all brick liners. 4. Rotate the anchor up and out of the way and slide the right hand side panel against the fi rebox side. 1. Inside the fi rebox, on the top of each side, release Rotate the anchor back down to hold the panel. - Page 18 Ceramic Logs INSTALLATION 2. Place the rear log centering it side to side in the 5. Identify the right cross log; it has fi rebox. Position forward until it sits against the a hole under on of its end and it is sheet metal return behind the burner.
-
Page 19: Window Refi Tting
Window Refi tting INSTALLATION 1. To refi t the window, hook its top part to the fi rebox’s opening frame. Make sure that the wider part of the window frame is at the bottom. 2. While you hold it, push in and turn the two top spring-loaded bolts a quarter turn to engage their pin. -
Page 20: Remote Control Handset Wall Holder Installation
Remote Control Handset Wall Holder Installation INSTALLATION The remote control kit for this fi replace comes complete with a wall-mounted holder. Packing Contents: Alternative 2 Alternative 3 This holder is not required in all installations 1 Wall Bracket A but is provided as an optional feature for 2 Screws B those customers who wish to mount the 1 Screw C... -
Page 21: Owner's Information
Solid wood fl ooring in front of as a seat or shelf. Solid wood fl ooring in front of NOTE: This is a problem beyond Miles Industries’ the fi replace (if allowed) may shrink during the the fi... - Page 22 Owner’s Information OWNER’S INFO Soot or dust can be brushed from the ceramic logs WARNING and fi rebox walls using a soft brush. Dust can also DO NOT TOUCH THE GLASS WHILE IT IS HOT! DO NOT TOUCH THE GLASS WHILE IT IS HOT! be removed from the burner using a soft brush after Let the fi...
- Page 23 Should the safety switch require replacement, only use battery for its handset. Batteries should last one to two parts supplied by Miles Industries. seasons, depending on usage. Removing the batteries in the off-season will extend the battery life. Should the...
-
Page 24: Remote Control Operation
Remote Control Operation OWNER’S INFO Your fi replace remote control helps you get the comfort, convenience and aesthetics you want from your gas fi replace. The remote controls your fi replace in different ways. IMPORTANT: BEFORE YOU BEGIN, please note that on this system, the settings of time, temperature and automatic ON/OFF can only be programmed when the function display is fl... - Page 25 Remote Control Operation OWNER’S INFO Setting the fl ame Use this setting when you want a particular fl ame level. For instance, you want to watch fl ames burn at their highest level and you don’t mind if the room is too hot.
-
Page 26: Options
Options OWNER’S INFO Venting (required) Hearth Gate (optional) Approved venting accessories as per local codes. Hearth gates such as Cardinal’s VersaGates are available at retail stores carrying safety products for children. Inner Front (required) See your dealer for your choice of Inner Fronts. Outer Surrounds, Trims &... -
Page 27: Lighting Instructions
Lighting Instructions OWNER’S INFO FOR YOUR SAFETY READ BEFORE LIGHTING WARNING: If you do not follow these instructions exactly, a fire or explosion may result causing property damage, personal injury or loss of life. A. This appliance has a pilot, which must be lighted by hand. When lighting the pilot, follow these instructions exactly. -
Page 28: Warranty
1. Extended Warranty Coverage For a period of up to ten (10) years, Miles Industries Ltd., (the “Company”) or its appointed distributor will at its option pay the initial purchaser for the repair of, or will exchange the following parts or components which are found to be defective in material or... -
Page 29: Spare Parts
Spare Parts OWNER’S INFO Part Part Code Description Code Description Number Number Exhaust Slide Assembly 4000127 Pipe Connector 220K891 Port Cover 4001820AH Thermocurrent Interruptor 4000202 Log Support 4001841 GV34 Valve w by-pass 125 4000056 Side Bricks Anchors (2) 4001283 Inlet Brass Connector 4000746 Top Mounting Bracket 4000136BY... - Page 30 Spare Parts OWNER’S INFO...
- Page 31 Reason for Purchase: Performance Flame Appeal Design Control Previous owner Recommendation Price Other Dealer Name: Address: City: Province/State: Postal Code/Zip: Phone: ( Cut out page, fi ll information, and mail to Miles Industries Ltd. Online Warranty registration at www.valorfi replaces.com...
- Page 32 Tape Shut Fold here Postage needed Miles Industries Ltd. 190 - 2255 Dollarton Highway North Vancouver, BC V7H 3B1 Canada Online Warranty registration at www.valorfi replaces.com Thank you for choosing a Valor Product...
Need help?
Do you have a question about the LEGEND 738BXN NG and is the answer not in the manual?
Questions and answers