Table of Contents
Advertisement
Quick Links
738BXN (NG) & 738BXP (LPG)
WARNING: If the information in these
instructions is not followed exactly, a fi re
or explosion may result causing property
damage, personal injury or loss of life.
Do not store or use gasoline or other
fl ammable vapors and liquids in the vicinity
of this or any other appliance.
WHAT TO DO IF YOU SMELL GAS
• Do not try to light the appliance.
• Do not touch any electrical switch; do not
use any phone in your building.
• Immediately call your gas supplier from
a neighbor's phone. Follow the gas
supplier's instructions.
• If you cannot reach your gas supplier, call
the fi re department.
Installation and service must be performed
by a qualifi ed installer, service agency or the
gas supplier.
4001379-10
©2012, Miles Industries Ltd.
L
EGEND
Gravity Vent Gas Insert
Installation & Owner's Manual
HOT GLASS WILL
CAUSE BURNS.
DO NOT TOUCH GLASS
UNTIL COOLED.
NEVER ALLOW CHILDREN
TO TOUCH GLASS.
Manufactured by
MILES INDUSTRIES LTD., British Columbia, Canada
www.valorfi replaces.com
IN STA LLER
Leav e t his manua l
with the applia nce .
C ON SU MER
Ret ain this ma nual
for f uture r efe re nce.
Please read this manual BEFORE installing
and operating this appliance.
This appliance may be installed in an after-
market permanently located, manufactured
(mobile) home where not prohibited by local
codes.
This appliance is only for use with the type
of gas indicated on the rating plate. This
appliance is not convertible for use with
other gases, unless a certifi ed kit is used.
This appliance is a domestic room-heating
appliance. It must not be used for any other
purposes such as drying clothes, etc.
This appliance is suitable for installation in a
bedroom or bed sitting room.
Massachusetts: The piping and fi nal gas
connection must be performed by a licensed
plumber or gas fi tter in the State of Massa-
chusetts.
Ce guide est disponible en français sur demande.
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for Miles Industries 738BXN (NG)
Summary of Contents for Miles Industries 738BXN (NG)
- Page 1 fi tter in the State of Massa- by a qualifi ed installer, service agency or the chusetts. gas supplier. Ce guide est disponible en français sur demande. Manufactured by MILES INDUSTRIES LTD., British Columbia, Canada www.valorfi replaces.com 4001379-10 ©2012, Miles Industries Ltd.
-
Page 2: Table Of Contents
Ignition Spark Check ........22 The information contained in this installation manual is believed to be correct at the time of printing. Miles Industries Ltd. reserves the right to change or modify any information or speci- fi cations without notice. Miles Industries Ltd. -
Page 3: Safety Precautions
Safety Precautions READ and UNDERSTAND all instructions carefully This unit MUST be used with a vent system as before starting the installation. FAILURE TO FOLLOW described in this installation manual. NO OTHER vent these installation instructions may result in possible fi re system or components MAY BE USED. -
Page 4: Safety And Your Fireplace
Safety and Your Fireplace Safety and Your Fireplace Please Read and Carefully Follow all Safety Warnings and Operating Instructions Contained in Your Owners Manual (Replacement Manuals are available by contacting our service department at 1-800-468-2567 or visit www.valorfi replaces.com). hot surface. Please Follow These Important A physical barrier is strongly Child Safety Precautions and... -
Page 5: Owner's Information
Owner’s Information INFORMATION Thank You ... WARNING For purchasing a Valor by Miles Industries. Your new radiant gas heater is a technical appliance that must EXTREMELY HOT!!! be installed by a qualifi ed dealer. Each Valor fi replace - READ the SAFETY information on pages 3... - Page 6 NOTE: This is a problem beyond Miles Industries’ engage their pin. control and is not covered under warranty. 3. Push in the bottom of the window against •...
- Page 7 OWNER’S Owner’s Information INFORMATION Remote Control Handset Wall Holder Soot or dust can be brushed from the ceramic logs and fi rebox walls using a soft brush. Dust can also Your fi replace equipment includes a wall holder to be removed from the burner using a soft brush after store the handset.
- Page 8 How to Ensure Your Fireplace Cannot Be Turned ON Inadvertently Should the safety switch require replacement, only use parts supplied by Miles Industries. The best way to ensure your fi replace will not turn on is to turn it off, including pilot—see above.
-
Page 9: Remote Control Operation
OWNER’S Remote Control Operation INFORMATION Your fi replace remote control helps you get the comfort, convenience and aesthetics you want from your gas fi replace. The remote controls your fi replace in different ways. IMPORTANT: BEFORE YOU BEGIN, please note that on this system, the settings of time, temperature and automatic ON/OFF can only be programmed when the function display is fl... - Page 10 OWNER’S Remote Control Operation INFORMATION Setting the fl ame Use this setting when you want a particular fl ame level. For instance, you want to watch fl ames burn at their highest level and you don’t mind if the room is too hot.
-
Page 11: Options
OWNER’S Options INFORMATION Venting (required) Hearth Gate (optional) Approved venting accessories as per local codes. Hearth gates such as Cardinal’s VersaGates are available at retail stores carrying safety products for children. Inner Front (required) See your dealer for your choice of Inner Fronts. Outer Surrounds, Trims &... -
Page 12: Lighting Instructions
OWNER’S Lighting Instructions INFORMATION FOR YOUR SAFETY READ BEFORE LIGHTING WARNING: If you do not follow these instructions exactly, a fire or explosion may result causing property damage, personal injury or loss of life. A. This appliance has a pilot, which must be lighted by hand. When lighting the pilot, follow these instructions exactly. -
Page 13: Specifi Cations
OWNER’S Specifi cations INFORMATION Approval & Codes *High Altitude Installations This appliance is certifi ed to ANSI Z21.88-2009 / CSA I nput ratings are shown in BTU per hour and are 2.33-2009 American National Standard / CSA Standard certifi ed without deration for elevations up to 4,500 feet for Vented Gas Fireplace Heaters for use in Canada (1,370 m) above sea level. -
Page 14: Overview
QUALIFIED Overview INSTALLER This appliance, as supplied, may ONLY be installed in an existing unaltered, functioning solid-fuel burning fi replace with a working fl ue and constructed of non-combustible material. This appliance is APPROVED for installation into combustible type construction only when using the 770ZCK Zero Clearance Kit (see separate instructions packaged with the kit for details). -
Page 15: Dimensions
QUALIFIED Dimensions INSTALLER 28-5/8” (727 mm) 19-1/2” (495 mm) 12” (305 mm) or 12-5/8” (321 mm) Varies with outer trim options Optional Outer Trim or Surround sold separately 7-7/8” (200 mm) or 8-1/2” (216 mm) Varies with outer trim options 20”... -
Page 16: Clearances
QUALIFIED Clearances INSTALLER WARNING Some materials or items, although safe, may discolor, shrink, warp, crack, peel, Some materials or items, although safe, may discolor, shrink, warp, crack, peel, and so on because of the heat produced by the fi replace. Avoid placing candles, and so on because of the heat produced by the fi... -
Page 17: Venting
QUALIFIED Venting INSTALLER Vent Location Typical Vent Installation The vent terminal must be located through the roof. This gravity vent appliance is designed to opreate when an undistrubed Terminal Cap airfl ow hits the outside vent terminal from any direction. Check local codes for allowable vertical vent termination. -
Page 18: Installation Planning
QUALIFIED Installation Planning INSTALLER Only qualifi ed licensed or trained personnel should install this appliance. Installer—READ THIS FIRST 1. YOU NEED TO KNOW FROM THE 9. Install the remote control system. HOMEOWNER what accessories (surround, 10. Install bricks and logs. door, etc.) will be installed with this fi... -
Page 19: Appliance Preparation
QUALIFIED Existing Fireplace Preparation INSTALLER Existing Glass Doors and Wire Screens Attach Warning Conversion Plate to Existing Fireplace (label supplied loose with 738BX Existing glass doors must be permanently removed heater) prior to installing the 738BX insert. Attach the “This fi replace has been converted...” Combustible Mantels label to the existing fi... -
Page 20: Venting Installation
QUALIFIED Appliance Preparation INSTALLER Venting Installation IMPORTANT: This appliance’s venting system requires room air to be used in the combustion process. 1. Rough-in one 3” diameter vent liner into the existing chimney system from the roof. Be careful not to tear or damage the liner in the process. -
Page 21: Supply Gas Installation
QUALIFIED Supply Gas Installation INSTALLER Pressure Test Points The gas supply inlet connection is a 3/8” NPT female connector and is located on the left hand side of the The minimum supply pressure is given in the section control valve. Specifi... -
Page 22: Ignition Spark Check
QUALIFIED Ignition Spark Check INSTALLER The pilot burner and electrode unit are at the left end of the burner. Push in the lighting knob and turn it counter-clockwise through the “IGN” position to “PILOT”. A spark should fl ash across from the pilot electrode to the pilot burner shield as shown below. Thermostat Knob Gas Control Knob... -
Page 23: Remote Control Preparation
QUALIFIED Remote Control Preparation INSTALLER CAUTION CAUTION DO NOT PUT BATTERIES IN THE REMOTE DO NOT USE a screwdriver or other metallic object to CONTROL RECEIVER until the wires are con- remove the batteries from the receiver or the handset! nected to the burner control unit as short- This could cause a short-circuit to the receiver. -
Page 24: Ceramic Bricks Installation
QUALIFIED Ceramic Bricks installation INSTALLER The following guidelines apply for all brick liners. 4. Rotate the anchor up and out of the way and slide the right hand side panel against the fi rebox side. 1. Inside the fi rebox, on the top of each side, release Rotate the anchor back down to hold the panel. - Page 25 QUALIFIED Ceramic Logs Installation INSTALLER 2. Place the rear log centering it side to side in the 5. Identify the right cross log; it has fi rebox. Position forward until it sits against the a hole under on of its end and it is sheet metal return behind the burner.
-
Page 26: Window Refi Tting
QUALIFIED Window Refi tting INSTALLER 1. To refi t the window, hook its top part to the fi rebox’s opening frame. Make sure that the wider part of the window frame is at the bottom. 2. While you hold it, push in and turn the two top spring- loaded bolts a quarter turn to engage their pin. -
Page 27: Remote Control Handset Wall Holder Installation
QUALIFIED Remote Control Handset Wall Holder Installation INSTALLER The remote control kit for this fi replace comes complete with a wall-mounted holder. Packing Contents: Alternative 2 Alternative 3 This holder is not required in all installations 1 Wall Bracket A but is provided as an optional feature for 2 Screws B those customers who wish to mount the... -
Page 28: Warranty
1. Extended Warranty Coverage For a period of up to ten (10) years, Miles Industries Ltd., (the “Company”) or its appointed distributor will at its option pay the initial purchaser for the repair of, or will exchange the following parts or components which are found to be defective in material or... -
Page 29: Spare Parts
OWNER’S Spare Parts INFORMATION Part Part Code Description Code Description Number Number Exhaust Slide Assembly 4000127 Warning Hot Glass Plate 4003093 Port Cover 4001820AH Thermocurrent Interruptor 4000202 Log Support 4001841 GV34 Valve Assembly NG 4003096 Side Bricks Anchors (2) 4001283 GV34 Valve Assembly LPG 4003109 Top Mounting Bracket... - Page 30 OWNER’S Spare Parts INFORMATION 35a, 35b...
-
Page 31: Miles Industries Ltd
Serial Number: Date Purchase (yyyy-mm-dd): Dealer: Customer Information First Name: Last Name: Contact Information Email: Mailing Address Address: City: Province/State: Postal/Zip Code: Country: Cut out page, fi ll information, and mail to Miles Industries Ltd. Online Warranty registration at www.valorfi replaces.com... -
Page 32: Miles Industries Ltd
Tape Shut Fold here Postage needed Miles Industries Ltd. 190 - 2255 Dollarton Highway North Vancouver, BC V7H 3B1 Canada Online Warranty registration at www.valorfi replaces.com Thank you for choosing a Valor Product...
Need help?
Do you have a question about the 738BXN (NG) and is the answer not in the manual?
Questions and answers