Operator Panel Service Check; Paper Feed Service Checks; Paper Jam Error Indication During Post - Lexmark X46x series Service Manual

Operator panel service check

Inspect the operator panel cable for damage. Make sure the cable is plugged in securely. Run POST, and check
each light for proper operation. See
Touch screen operator panel service check
FRU
Operator panel Display
Operator panel
keyboard
Controller board
Warning: Do not
replace the engine
board and controller
board at the same
time. Each board
contains the printer
settings. When either
of these boards is new,
it obtains the settings
from the other board.
Settings are lost when
both are new and
replaced at the same
time.

Paper feed service checks

Paper jam error indication during POST

FRU
Fuser (exit sensor)
Input/duplex sensor
Manual feed sensor
"Power–On Self Test (POST) sequence" on page
Action
Touchscreen display
If the touchscreen display does not come on or indicator LED on the keyboard doesn't
illuminate, then open the controller board cage and locate the operator panel connector at
J34. Make sure the cable is properly connected to the controller board and the controller
board has input voltage to it.
With the printer on, verify the following on connector J34:
• Pins 1, 3, 5, and 6: 3.3 v
• Pin 10, 16, 17, and 18: 5 v
• Pins 2, 9, and 15: GND
If any are incorrect, then see
If these are approximately correct and the operator panel is not functioning:
1. Turn the printer off.
2. Remove the left and right covers,
3. Tilt the operator panel keyboard and verify the UICC cable is properly connected to the
keyboard at connector J10.
4. If the cable is properly connected at both ends, check the cable for continuity. If the
cable fails, replace the UICC cable.
5. Reconnect the UICC cable, and verify the display ribbon cables are properly connected
to J3 and J12 on the keyboard.
6. Restart the printer. If the eight LEDs on the bottom of the keyboard card illuminate, but
the display fails to illuminate, replace the touchscreen display.
7. If the eight LEDs fail to illuminate, replace the keyboard.
Button keypad
If the touchscreen is ok, POR into Diagnostic mode, and perform the Button test under the
Hardware tests. If the buttons do not respond, then replace the keyboard.
Action
If the exit sensor flag, which is visible at the back of the fuser, is in any position other than
vertical, then the printer will display a paper jam. Make sure the flag is operating freely.
Replace the fuser if the sensor is damaged.
Make sure the input paper feed sensors are working properly. A stuck or incorrectly installed
sensor causes a paper jam indication.
"Controller board service check" on page
7014-xxx
2-1.
2-35.
2-43
Diagnostics information