7014-xxx
Printhead removal
1.
Remove the top cover. See
2.
Remove the right side cover. See
3.
Disconnect the two cables (A), and unroute them back through the frame toward the printhead.
4.
Remove the three screws (B).
Note: Use a pencil to mark the screw locations of the printhead on the metal frame. Align the new printhead
relative to the location of the old printhead. See
5.
Remove the printhead.
4-72
"Top cover assembly removal" on page
"Right side cover removal" on page
A
"Printhead assembly mechanical adjustment" on page
B
4-80.
4-77.
3-39.