GreenWorks 51142 Operator's Manual page 19

ASSEMBLY
CONNECTING THE GARDEN HOSE
C A U T I O N :
Always observe all local regulations when connecting hoses to the water main. Some areas have
restrictions against connecting directly to public drinking water supply to prevent the feedback of
preventer is usually permitted.
The water supply must come from a water main. NEVER use hot water or water from pools,
lakes, etc. Before connecting the garden hose:

Uncoil the garden hose.

Run water hose with motor in OFF position until a steady stream of water appears to
clean any
debris from the hose.

Inspect the screen in the water intake.

If the screen is damaged, do not use the machine until the screen has been replaced.

If the screen is dirty, clean it before connecting the garden hose to the machine.

With the hose faucet turned completely off, attach the end of the garden hose to
W A R N I N G
Always use the pressure washer in the position shown, laying down. Never try to use in the
upright position. Danger of tipping over and damage to the motor and/or pump may occur.
W A R N I N G
Always ensure that the garden hose is connected to the unit and that the faucet is turned on,
before the power to the unit is switched on. Pump damage will occur if these steps are not
followed.
the water intake. Tighten by hand.
(See Figure 9.)
1 6
Fig. 9