Electrical - GreenWorks 51142 Operator's Manual

ELECTRICAL

W A R N I N G
The double insulated system is intended to protect the user from shock resulting from a break in
the product's internal insulation. Observe all normal safety precautions to avoid electrical shock.
DOUBLE INSULATED
Double insulation is a concept in safety in electric power tools, which eliminates the need for the
usual three-wire grounded power cord. All exposed metal parts are isolated from the internal
metal motor components with protecting insulation. Double insulated products do not need to be
grounded.
NOTE: Servicing of a product with double insulation requires extreme care and knowledge of the system and
your nearest authorized service center for repair. Always use original factory replacement parts when
servicing.
ELECTRICAL CONNECTION
This product has a precision-built electric motor. It should be connected to a power supply that is
120 volts, 60 Hz, AC only (normal household current). Do not operate this product on direct
current (DC). A substantial voltage drop will cause a loss of power and the motor will overheat. If
the product does not operate when plugged into an outlet,double-check the power supply.
EXTENSION CORDS (
See Figure 1.)
When using a power tool at a considerable distance from a power source, be sure to use an
extension cord that has the capacity to handle the current the product will draw. An undersized
cord will cause a drop in line voltage, resulting in overheating and loss of power. Use the chart to
determine the minimum wire size required in an extension cord. Only round jacketed cords listed by
Underwriter's Laboratories (UL) should be used. When working outdoors with a product, use an
extension cord that is designed for outside use.This type of cord is designated with "WA" or "W" on
the cord's jacket. Before using any extension cord, inspect it for loose or exposed wires and cut or
worn insulation. It is possible to tie the extension cord and power cord in a knot to prevent
the plug end of the power cord into the receptacle end of the extension cord. This method can
also be used to tie two extension cords together..
Pressure washer power cord
Fig. 1
9