LifeFitness E1 Owner's Manual page 26

The contact heart rate
sensors are not reading
my heart rate correctly.
"STRIDE" is blinking
(E5)
Activity Zone keeps turn-
ing OFF. (E5)
CoachZone keeps turn-
ing off. (E3)
Stride length adjustment
is not working. (E5)
Stride length automati-
cally changes. (E5)
Stride adjustment seems
loud. (E5)
Stride length feels long
on one side. (E5)
Stride changes when
exiting Energy Saver
Mode. (E5)
Activity Zone displays
E5. (E5)
Activity Zone display set-
tings won't work. (E5)
Activity Zone displays
strange information in
the digital display. (E5)
Errors displayed in the
Activity Zone. (E5)
iPod is not recognized.
Note: Applies to Track+
Console only.
24
Be sure to grasp the sensors firmly and keep hands still. If heart rate seems substantially
higher or lower than expected, remove hands from sensors until heart rate disappears.
Tips for contact heart rate:
1. Dry hands to prevent slipping on the sensors.
2. Apply hands to all four sensors (two in each hand).
3. Grasp sensors firmly.
4. Apply constant pressure to the sensors.
5. May need to wait longer for heart rate to display.
Note: The heart rate hand pulse sensors provide an approximate heart rate value. The
sensors are not medical devices and should not be used in any type of medical applica-
tion.
Your Duty Cycle is on, which prevents Over Actuation. Refer to Section 7.2, page 22 for
more information on how to Turn Off.
The Activity Zone will enter Energy Saver Mode at the same time as the console.
The CoachZone is preset to turn the lights off after 5 minutes of inactivity in order to save
power.
Turn off the cross-trainer's power. Turn the power back on after 30 seconds and try the
stride adjustment again. Note: Duty Cycle may prevent Stride Adjustment. Refer to Sec-
tion 6.1, page 16 for information on how to change.
Check to see if the Leg Sculptor mode is turned on. The Leg Sculptor icon is illuminated
when on. The Leg Sculptor automatically adjusts the stride every 2 minutes during a
workout. To turn the Leg Sculptor OFF, press the Leg Sculptor key.
Some noise from the stride adjustment is normal. The sound of the motors will vary de-
pending on the load.
Turn the unit off. Turn the unit back on after 30 seconds. Try the unit again.
When the E5 wakes up from Energy Saver Mode, the stride length adjusts to the home
position.
One of the keys on the Activity Zone is stuck in a pressed in position. Check to see if you
can dislodge the Leg Sculptor, Stride Up, or Stride Down key. Once the key is dislodged,
the "E5" will disappear.
You have accessed the Settings Menu. To exit the Settings Menu press the Leg Sculptor
key until the Settings Menu has been exited.
You may have accessed the Settings Menu or Diagnostics Menu. Press the Leg Sculptor
continuously until the menu is exited.
Turn the unit off and turn back on again to reset the Activity Zone.
This is displayed if your version of the iPod Player is not supported by the cross-trainer.
It may also be displayed if the connector on the cross-trainer or iPod is damaged.