LifeFitness E1 Owner's Manual page 11

The Total-Body Elliptical Cross-Trainer is equipped with front and rear wheels so that it is simple to push or pull the
Total-Body Elliptical Cross-Trainer to its final destination. To use the wheels make sure that the levelers are twisted up far
enough so that all wheels (A) can engage with the floor.
Once the Total-Body Elliptical Cross-Trainer is properly positioned, allow enough space in the front of the Total-Body El-
liptical Cross-Trainer for the movement of the pedal levers. Also be sure to allow space on the side so that it is easy to
mount the Total-Body Elliptical Cross-Trainer from the side.
A
A
E1/E3 E5
CAUTION: Make certain you have plenty of room for the swing of the moving arms. E5 ONLY: Test the Total-Body Ellipti-
cal Cross-Trainer at all stride lengths before finalizing its location.
CAUTION: Place Total-Body Elliptical Cross-Trainer in a dry place. Do not place in highly humid areas, like near swim-
ming pools, as rust and corrosion may occur.
h s t -b E c -t
ow to tabilizE thE otal ody lliptical ross rainEr
Once the cross-trainer is positioned in the room lower the levelers (B) on the
front stabilizer to contact the floor. All four
wheels must be completely off the floor. The levelers will keep the cross-trainer
fixed to the floor while using it.
CAUTION: Do not use the Total-Body Elliptical Cross-Trainer without the level-
ers touching the floor.
After placing the Total-Body Elliptical Cross-Trainer where it will be used, check B
the stability. If there is even a slight rocking motion, or the unit is not stable the
levelers will need to be adjusted. Determine which leveler is not resting firmly
D
on the floor. To adjust the levelers downward twist the rubber portion of the leg
counterclockwise. To adjust the levelers upward twist the
rubber portion of the leg clockwise.
After adjusting the levelers, tighten the jam nuts (D) against the stabilizer to lock the levelers in place.
Note: After the Cross-Trainer is level, be sure to tighten the nut on the leveler against the stabilizer tube. If this is not tight-
ened, noise will occur.
9