Scanner Component Removal Procedures; Flatbed Removal - Lexmark X543 Series Service Manual

Scanner component removal procedures

Flatbed removal

1.
Remove the AIO rear cable cover. See
2.
Remove the rear shield. See
3.
Remove the left cover. See
4.
Remove the ADF unit. See
page 4-64.
5.
Disconnect the CCD cable form JCCD1 on the controller board.
6.
Remove the toroids (A) from the CCD cable. The toroids will be reused on the new flatbed unit.
"AIO back cable cover removal" on page
"Rear shield removal" on page
"Left cover removal" on page
"Duplex ADF removal" on page 4-63
4-8.
4-7.
4-4.
or "Simplex ADF removal" on
A
Repair information
7525-xxx
4-53