Lexmark X543 Series Service Manual page 74

7525-xxx
Fax error log codes (continued)
Error code
882
883
884
885
886
887
888
889
88A
901
902
903
904
905
906
2-30
Service Manual
Description
Failure to transmit training successfully
in V17, V29 terminal modulation
schemes.
Failure to transmit training successfully
in V17,V27 terminal modulation
schemes.
Failure to transmit training successfully
in V29, V27 terminal modulation
schemes.
Failure to transmit training successfully
in V17terminal modulation scheme.
Failure to transmit training successfully
in V29 terminal modulation scheme.
Failure to transmit training successfully
in V27 terminal modulation scheme.
Failure to transmit training successfully
at 2400 bps in V27 terminal modulation
scheme.
Failed to connect at the minimum
speed supported by the MFP.
Failed to connect using V.34
modulation scheme.
No fax tones detected from remote
end.
No dial tone detected.
Busy tone detected.
Hardware error detected.
A timeout occurred after dialing the
number and waiting for a response.
Fax cancelled by user.
Action
• Select a lower "Max Speed" under Fax
Send settings.
• Adjust the "Transmit Level".
• Check line quality.
• Select a lower "Max Speed" under Fax
Send settings.
• Adjust the "Transmit Level".
• Check line quality.
• Select a lower "Max Speed" under Fax
Send settings.
• Adjust the "Transmit Level".
• Check line quality.
• Select a lower "Max Speed" under Fax
Send settings.
• Adjust the "Transmit Level".
• Check line quality.
• Select a lower "Max Speed" under Fax
Send settings.
• Adjust the "Transmit Level".
• Check line quality.
• Select a lower "Max Speed" under Fax
Send settings.
• Adjust the "Transmit Level".
• Check line quality.
• Adjust "Transmit Level".
• Check line quality.
• Adjust "Transmit Level".
• Incompatible connection.
• Check line quality.
• Adjust to a lower modulation scheme.
• Adjust Transmit Level Receive
Threshold values.
• Verify destination phone number.
• Verify that the remote fax is authorized
to receive faxes.
• Check by enabling 'Behind a PABX'
setting.
• Check phone line.
• Check MFD modem hardware.
Check with remote end if successive
attempts fail.
See "Modem / fax card service check"
on page 2-70.
Check with remote end if successive
attempts fail.
No action needed.