Sony PMW-EX3 Operating Instructions Manual page 39

3
Insert the cheek pad from the back of
the camcorder and secure it with the
supplied screws.
Align the holes on the bottom of the mount
frame of the cheek pad with those of the
camcorder.
4
Return the shoulder pad to its original
position.
1
3
2
1 Insert the axis of the shoulder pad in the
hole of the camcorder.
2 Secure the fixing plate to its original
position with the screw.
3 While holding the knob, push in on the
shoulder pad.
5
Attach the cable clamp you removed in
2
step .
Align the hole of the cable clamp with those
on the mount frame of the cheek pad (at the
top of the pole) and the camcorder then
secure them all together with the supplied
screw.
(Keep the original screw removed in step
for future use.)
Cable clamp
Mount frame of
the cheek pad
6
3
To attach the DC cable clamp
The supplied DC cable clamp can be attached to
the frame of the cheek pad at one of the accessory
screw holes on the opposite side of the pad.
The DC power output cable (page 28) of the BC-
U1/U2 connected to the DC IN connector can be
tied down with the clamp.
2
Supplied screw
While holding the pole upward, flip the
pad toward the side panel of the
camcorder.
Using the Cheek Pad
Pole of the
cheek pad
Cheek pad
39