The POWER indicator of the PHU-220R
lights in green.
Subsequently, the ACCESS lamp of the
camcorder lights in red then changes to green
once the unit is ready for use.
Disconnecting the PHU connection cable
Operate in the same manner as when you remove
an SxS memory card from the slot.
Formatting the PHU-220R
For a PHU-220R that is not formatted or that was
formatted with another system, a message to
confirm if formatting is to be executed is
displayed in the viewfinder.
Any PHU-220R formatted with a device other
than this camcorder cannot be used with the
camcorder.
To execute formatting
If the message for formatting is displayed,
turn the jog dial or tilt the joystick to select
“Execute” then press the dial or joystick.
Formatting begins.
An in-progress message and status bar (%) are
displayed, and the ACCESS lamp lights in red.
When formatting is completed, a completion
message is displayed for three seconds.
To format by menu operation
When no formatting message is displayed in the
viewfinder, you can execute formatting using
“Format Media” (page 132) of the OTHERS
menu in the same manner.
Notes
• Formatting for the PHU-220R on this
camcorder is “Quick Format” with which only
the managerial data are erased. To erase the
recording data completely, connect the unit to a
PC and perform “Full Format.”
• The PHU-220R to be used with this camcorder
must be formatted using the format function of
this camcorder. Any PHU-220R formatted with
another device must be formatted again with
this camcorder.