Swing Arm - Arctic Cat 2007 Y 12 Service Manual

FOR ARCTIC CAT ATV DISCOUNT PARTS CALL 606-678-9623 OR 606-561-4983
7. Remove the ATV from the support stand.
! WARNING
After removing and installing components that are
brake-related, ALWAYS check and adjust brakes as
necessary before operating the ATV.

Swing Arm

REMOVING
1. Secure the ATV on a support stand to elevate the
rear wheels; then remove the wheels.
! WARNING
Make sure the ATV is solidly supported on the sup-
port stand to avoid injury.
2. Remove two cap screws securing the brake cali-
per to the axle housing.
3. Remove drive chain, hubs, spacers, and axle as
necessary (see Rear Hub/Drive Axle in Section
6).
NOTE: Do not remove more components than
necessary to perform the intended service. The
axle housing will separate from the swing arm with
all components attached if necessary.
4. Remove the four cap screws (A) securing the
axle housing to the swing arm; then remove the
axle housing.
www.mymowerparts.com
Back
7-6
KM207
Back to TOC
5. Remove the cap screws securing the skid plate
and rear chain guard; then remove the skid plate
and rear chain guard.
6. Remove the cap screw securing the shock
absorber to the swing arm.
Back to Section TOC
KM217B
KM212A
MD2014
MD2315
Next