Honeywell VISTA CADVR-1004C User Manual page 31

i. Trigger recording: Place a check mark '√' for the channel you need to trigger, when
there is alarm on the setting channel, will trigger to other channels.
ii. Snapshot: Place a check mark '√' in front the channel, when the setting channel has
alarm, will snap a picture.
iii. Send E-mail: Place a check mark '√', when there is alarm, will send the snapped
picture to the mailbox you set.
iv. Alarm output: Place a check mark '√', will trigger the external alarm.
v. Alarm output duration: Click the inverted triangle, options: 10s/ 30s/ 1min/ 3 min/ 5min/
10min/ 15min/ 30min.
vi. Buzzer: Click the inverted triangle, options: None/10s/ 30s/ 1min/ 3 min/ 5min/ 10min/
15min/ 30min.
vii. Pop-out image: Click the inverted triangle, options: None/ CH1/ CH2...
viii. Post-record: Click the inverted triangle, options: 10s/ 30s/ 1min/ 3 min/ 5min/ 10min/
15min/ 30min.
ix. Pre-record: Click the inverted triangle, options: None/ 5s/ 10s
x. Trigger PTZ: None/ Cruise line/ Preset point
xi. Attention: Click "Apply" after setup.
Others: HDD Invalid/HDD full/ IP conflict alarm settings.
31