Table of Contents
Advertisement
mounting collectors on a metal roof
7.
fit
To assist in fitting the collectors there are a series of m5 threaded holes
collectors
along the mounting rails. in the solar collector fittings kit are m5 fasteners.
These should be inserted into the holes in the rail before the collectors are
fitted. These will act as 'stoppers'.
Fit the collectors into the mounting rails. The stoppers will position the
panels at the right height for the slots to align so the mounting fasteners
can insert easily. The stoppers should be removed after the collectors are
fitted.
8.
fit
Fit the first collector between the mounting brackets using fasteners
additional
supplied, do not fully tighten at this point. Fit the collector connectors
collectors
for two or three panel systems to the first panel. Fit second collector by
inserting the header tubes into the connectors and attach the collector to
the rail with fasteners provided. Tighten fasteners on the first collector.
Firmly push collectors together, tighten connectors and then tighten
fasteners on second collector. repeat from step 7 if fitting a third panel.
rinnai new Zealand Limited
Use lower holes
17
E-Frost Solar Collector Split System
install manual: 11497-a
Advertisement
Table of Contents
