Before You Start; Tools; Central Pay Models - Jim Chookagian NF3L Installation & Operation Manual

Before You Start

Tools

For most installations, the basic tools you will need
are:
1
1 Wrench
2 Screwdriver
3 Pliers
4 Socket Wrench
5 Level
Figure 1
803623 (EN)
3
2
© Published by permission of the copyright owner – DO NOT COPY or TRANSMIT
NOTE: A 20.32 cm (8 in.) coin drawer is required
for coin operated models.
NOTE: If the washer is delivered on a cold day
(below freezing), or is stored in an unheated room
or area during the cold months, do not attempt to
operate it until the washer has had a chance to
warm up.
NOTE: Install dryer before washer. This allows
4
room for attaching exhaust duct.
NOTE: Some moisture in the wash drum is normal.
Water is used during testing at the manufacturer.

Central Pay Models

5
The machine is shipped from the factory with the
Electronic Control Diagnostic Harness Assembly
unplugged. To avoid unauthorized manual
programming or vending perform the following steps.
D074I
1. Open service door. Refer to Figure 2.
2. Locate diagnostic harness on electronic control.
3. Plug connectors for "white/black" wire and "red/
blue" wire together.
1 Service Door
Installation
1
DRY2074N
Figure 2
7