Step 6: Remove The Shock Sleeves And Shipping Brace; Step 7: Wipe Out Inside Of Wash Drum - Jim Chookagian NF3L Installation & Operation Manual

Step 6: Remove the Shock Sleeves and
Shipping Brace
Remove front access panel by removing the two screws
at the bottom of the panel.
Remove the five bolts and lockwashers from shipping
brace with 14.3 mm (9/16 in.) wrench and remove
brace. Refer to Figure 10. One is holding the brace to
the weight. Remove this bolt first. Four bolts are
located on the washer base. Remove the two front
bolts next and then the two rear bolts. Remove all four
shock sleeves by pulling on the yellow rope. Remove
label from front side of front access panel and place on
backside of front access panel or shipping brace for
future reference.
NOTE: The shipping brace, bolts, washers and
shock sleeves should be saved and MUST be
reinstalled whenever the washer is moved more
than 1.2 m (4 ft.). Refer to Maintenance section for
instructions. Do not lift or transport washer from
front or without shipping materials installed.
Reinstall front access panel.
IMPORTANT: DO NOT tip washer more than
152.4 mm (6 in.) in any direction after shipping
brace has been removed. Shock absorbers may
separate and damage to washer may result. For
leveling purposes, the washer may be tilted a
maximum of 152.4 mm (6 in.) in any direction.
1
1 Shock Sleeves
2 Motor Mount
3 Hooked End of Shipping Brace
4 Bolts and Lockwashers
Figure 10
803623 (EN)
2
3
FLW2124N
4
FLW2124N
© Published by permission of the copyright owner – DO NOT COPY or TRANSMIT

Step 7: Wipe Out Inside of Wash Drum

IMPORTANT: Prior to first wash, use an
all-purpose cleaner, or a detergent and water
solution, and a damp cloth to remove shipping dust
from inside wash drum.
Figure 11
Installation
FLW2135N
FLW2135N
13