Step 3: Connect Fill Hoses - Jim Chookagian NF3L Installation & Operation Manual

NOTE: DO NOT slide washer across floor if the
leveling legs have been extended, as legs and base
could become damaged.
Remove rubber feet from accessories bag and place on
all four leveling legs.
Verify that unit doesn't rock.
2
1
6
5
1 Leveling Leg
2 Washer Base
3 Level
4 Wood Block
5 Locknut
6 Rubber Foot
Figure 4
803623 (EN)
3
FLW2134N
4
FLW2134N
© Published by permission of the copyright owner – DO NOT COPY or TRANSMIT

Step 3: Connect Fill Hoses

WARNING
Under certain conditions, hydrogen gas
may be produced in a hot water system
that has not been used for two weeks or
more. HYDROGEN GAS IS EXPLOSIVE. If
the hot water system has not been used
for such a period and before using the
washer, turn on all hot water faucets and
let the water flow from each for several
minutes. This will release any
accumulated hydrogen gas. The gas is
flammable. Do not smoke or use an open
flame during this time.
Water Supply
Water supply faucets must fit standard 19.1 mm
(3/4 inch) female garden hose couplings. DO NOT
USE SLIP-ON OR CLAMP-ON CONNECTIONS.
Recommended cold water temperature is 16° to
27° Celsius (60° to 80° Fahrenheit). Recommended
maximum hot water temperature is 51° Celsius
(125° Fahrenheit).
WARNING
To prevent personal injury, avoid contact
with inlet water temperatures higher than
51° Celsius (125° Fahrenheit) and hot
surfaces.
Models NF3LLFSG401UT06 and
NF3LLFSP401UT06: Water pressure must be a
minimum of 138 to a maximum of 689 kPa (20 to
100 psi) static pressure measured at the faucet.
All other models: Water pressure must be a minimum
of 138 to a maximum of 827 kPa (20 to 120 psi) static
pressure measured at the faucet.
NOTE: Water pressure under 138 kPa (20 psi) will
cause an extended fill time in the washer and may
not properly flush out the detergent dispenser.
The appliance is to be connected to the water mains
using new hose-sets and the old hose-sets should not
be reused.
Installation
W029
W750
9