Table of Contents
Advertisement
Installation
Turn on the water supply faucets and flush the lines for
approximately two minutes to remove any foreign
materials that could clog the screens in the water
mixing valve.
Connecting Hoses
Models NF3LLFSG401UT06 and
NF3LLFSP401UT06: To comply with water
regulations, this washing machine must be fitted with
an approved 3/4 inch single check valve to both the
hot and cold supplies between shut off valve and fill
hose. Refer to Figure 5. Maximum water flow rate to
the dispenser is 10 liters per minute.
Screw BLACK colored hose couplings with filter
screens onto water supply faucets and brass hose
couplings with rubber washers to water mixing valve
finger-tight and then approximately 1/4 turn with
pliers.
IMPORTANT: DO NOT cross thread or
overtighten couplings. This will cause them to leak.
Turn water on and check for leaks. If leaks are found,
retighten the hose couplings. Continue tightening and
rechecking until no leaks are found.
10
© Published by permission of the copyright owner – DO NOT COPY or TRANSMIT
COLD
HOT
7
6
5
1
Faucet
2
Fill Hoses
3
Install this End of Hose to Valve Connections
at Rear of Washer
4
Plain Rubber Washer (in accessory bag)
5
Install this End of Hose to Water Supply
Faucet (Black Colored Coupling for Metric)
6
Filter Screens (in accessory bag – screen
must face outward)
7
Check Valves (use on models
NF3LLFSG401UT06 and
NF3LLFSP401UT06)
Figure 5
IMPORTANT: All hoses should be checked on a
monthly basis for any visible signs of deterioration.
Any hose showing signs of deterioration should be
replaced immediately. All hoses should be replaced
every five years.
1
4
3
2
FLW2216N
803623 (EN)
Advertisement
Table of Contents
