Table of Contents
Advertisement
STEP 5 - Installing Camera in the Housing
1. Pull out on each housing control until it stops. This will get the controls
out of the way for installation of the camera.
2. Remove camera lanyard from camera if attached.
3. Place the Housing Front face down in your lap.
4. Extend the built-in camera flash before placing camera in housing.
5. Gently guide the Housing Back with camera attached into the Housing
Front at a slight angle so the Control Ring Gear and Housing Gear
engage properly. Visually check to see that the Gears are properly
engaged.
CAUTION: DO NOT allow the flash to bump into the housing's main
o-ring sealing surface or the housing top during installation. This could
cause the flash to be damaged or not extend properly in the housing.
STEP 6 - Closing the Housing
1. Once the back is properly
installed, the o-ring should touch
the housing all the way around.
There should be an even gap on
each side of the housing between
the housing and the back.
2. Lift the lid snaps so they are
extended and place each lid snap
into the corresponding hook on
the housing back.
3. To close the housing, push down on
the opposing lid snaps simultaneously
until they snap into place. Be sure
they are down far enough to engage
the Lid Snap Lock. The o-ring seal
should now appear as a solid black
line from the back of the housing.
Lid Hook
Even gap on
all four sides
Lid
Snap
Lid Snap Lock
Housing Back
O-ring
11
Advertisement
Table of Contents
