Step 2 - Opening The Housing; Step 3 - Attach Camera To Mounting Tray - Ikelite DSC-RX100M3/B Instruction Manual

STEP 1 - Initial Camera Setup
If close-up images are overexposed, adjust aperture setting and/or use
"-" Flash Exposure Compensation and/or back away, zoom in, and
then reshoot.
RAISE the camera flash before placing camera in housing (no housing
-
control is provided for this function).
** All camera user settings not listed should be set to the user's
preference.

STEP 2 - Opening the Housing

Lid Snaps have a Lock.
1. Push Lid Snap Locks forward and lift as shown.
Open opposing Lid Snaps simultaneously. Keep
pressure on the Lid Snaps so they do not fly
open quickly.
Some Lid Snaps have a lot of spring tension
once they go over center, so keep a firm grip on
each Lid Snap. Lid Snaps may also be opened
one at a time.
2. Remove the Housing Back.

STEP 3 - Attach Camera to Mounting Tray

1. The Mounting Tray for the camera is secured to the housing back.
Position the camera on the Mounting Tray.
2. Using a coin or screwdriver (preferred), secure the camera with the
Mounting Tray Bolt which threads into the camera's tripod socket,
Diagram B, page 9.
CAUTION:
Do not cross thread or overtighten the Mounting Tray Bolt as you may
damage the camera tripod socket threads.
8
- continued
Push Forward
Lift
Lid
Snap
Lock