Edit From A Camcorder - JVC DR-MV5S Instructions Manual

EDITING
42
EN

Edit From A Camcorder

You can use a camcorder as the source player and your unit as the
recording deck.
A If the camcorder has no S-VIDEO output connector:
STANDBY/ON
S-VIDEO VIDEO AUDIO
To [VIDEO/AUDIO
((MONO) L/R)] input
Audio/video cable
(not supplied)
Player
B If the camcorder has an S-VIDEO output connector (DVD
deck only):
STANDBY/ON
S-VIDEO VIDEO AUDIO
To
To [AUDIO] input
[S-VIDEO]
input
S-video cable
(not supplied)
Player
VHS DVD
VHS/DVD
VHS DUBBING DVD
Recorder
AUDIO/VIDEO OUT
VHS DVD
VHS/DVD
VHS DUBBING
Audio cable
(not supplied)
S-VIDEO OUT
AUDIO OUT
● Slide the TV/DVD switch to DVD.
1
Make connections.
A If the camcorder has no S-VIDEO output connector:
— connect the camcorder's AUDIO/VIDEO OUT connectors to the
unit's [VIDEO/AUDIO ((MONO) L/R)] input connectors on the front
panel.
● When using a monaural camcorder, connect its AUDIO OUT
connector to the [AUDIO-L] input connector on your unit.
B If the camcorder has an S-VIDEO output connector:
— connect the camcorder's AUDIO OUT and S-VIDEO OUT
REC
CH connectors to the unit's [AUDIO] and [S-VIDEO] input connectors
DV IN
on the front panel.
2
Press VHS/DVD on the unit repeatedly to select the recording
deck.
3
Press CH +/– to select "F-1".
● Set "FRONT AUX F-1" to "VIDEO" for the VIDEO input connector, or
"S-VIDEO" for the S-VIDEO input connector, depending on the
connector being used. (
4
Press REC MODE repeatedly to set the recording mode.
5
Start playback on the camcorder slightly before the actual point
from where you wish to start dubbing.
6
Press 7 on the unit to start recording. Or while holding 7, press
4 on the remote control. The dubbing starts.
7
Press 8 on the unit, then stop playback on the camcorder.
NOTES:
● All necessary cables can be obtained from your dealer.
● Refer to the camcorder's instruction manual for operating procedure.
● The quality of dubbed picture becomes poorer than that of the
original.
REC
CH
DVD
DV IN
Recorder
pg. 73)