Edit From A Camcorder - JVC DR-MH20SUJ Instructions Manual

Filename [DR-MH30UJ_09Editing.fm]
DR-MH30UJ_00.book Page 61 Monday, July 12, 2004 3:17 PM

Edit From A Camcorder

You can use a camcorder as the source player and your unit as the
recording deck.
A If the camcorder has no S-VIDEO output connector:
Recorder
AUDIO/VIDEO OUT
Player
B If the camcorder has an S-VIDEO output connector:
S-VIDEO input
Recorder
S-VIDEO OUT
AUDIO OUT
Player
Page 61
AUDIO/VIDEO input
Audio/video cable
(not provided)
AUDIO input
S-video cable
(not provided)
Audio cable
(not provided)
Slide the TV/CABLE/DBS/DVD switch to DVD.
1
Make connections.
A If the camcorder has no S-VIDEO output connector:
— connect the camcorder's AUDIO/VIDEO OUT connectors to the
unit's AUDIO/VIDEO input connectors on the front panel.
When using a monaural camcorder, connect its AUDIO OUT
connector to the AUDIO L input connector on your unit.
B If the camcorder has an S-VIDEO output connector:
— connect the camcorder's AUDIO OUT and S-VIDEO OUT
connectors to the unit's AUDIO and S-VIDEO input connectors on
the front panel.
2
Press HDD or DVD repeatedly to select the recording deck.
3
Press CH +/– to select "F-1".
Set "FRONT AUX F-1" to "VIDEO" for the VIDEO input connector, or
"S-VIDEO" for the S-VIDEO input connector, depending on the
connector being used. ( pg. 68)
4
Press REC MODE repeatedly to set the recording mode.
5
Start playback on the camcorder slightly before the actual point
from where you wish to start dubbing.
6
Press 7 on the unit to start recording. Or press and hold 7 and
press 4 on the remote control. The dubbing starts.
7
Press 8 on the unit, then stop playback on the camcorder.
NOTES:
All necessary cables can be obtained from your dealer.
Refer to the camcorder's instruction manual for operating procedure.
The quality of dubbed picture becomes poorer than that of the
original.
Masterpage:Right+
EDITING
61
EN
Monday, 12 July 2004 14:25