JVC DR-MV5S Instructions Manual page 60

ADVANCED RECORDING
60
EN
Free Rate Function
To record the entire program, the unit automatically sets the
appropriate recording mode depending on the combination of the
total time of the program to be recorded and either the remaining
disc space or the specified recording time (from 6 0 minutes to 4 8 0
minutes).
8 To record the entire program within the actual remaining
disc space
Select " F R (J U S T)" in a recording mode selection procedure.
● Note that this function is available only for timer programing recording
( pg. 31, 32).
8 To record the entire program by specifying the desired
recording time
Select " F R6 0 – F R36 0 " , " F R4 2 0" or " F R4 8 0" in a recording mode
selection procedure. ( pg. 28, 31, 32)
8 To record a 25-min. long daily program five times just on
the same DVD disc for example
Perform " V CR Plus+ ® Timer Programing" (
sure to set the recording mode to " F R125" and set Weekly/Daily
Rec Function to " M ON– F RI" in step
to the whole disc space.
Blank
When the same program is recorded in SP mode instead of in
" F R125" , the 5th program cannot be recorded.
Blank
NOTES:
● Y ou can program this unit to timer-record, regardless of the disc
remaining time. When the disc remaining time is not enough,
recording may stop in the middle of a program. To avoid this, make
sure of the disc remaining time before setting timer programing.
(Example) If you programed to timer-record for 6 0 minutes in SP
mode on a 120-minute disc, the disc remaining time would be 30
minutes in X P mode, 6 0 minutes in SP mode, 120 minutes in LP
mode, 180 minutes in EP mode, and 24 0 minutes in FR4 8 0 mode.
Timer-recording will not complete beyond these remaining times.
● The maximum recording time of " F R (J U S T)" m ode is the same as the
recording time of FR4 8 0 mode. When timer programing a long
program in " F R (J U S T)" m ode on a disc whose remaining time is
short, it is recommended to check the disc remaining time in FR4 8 0
mode to see if the remaining time is enough for the program.
● Even if more than one program are timer programed in " F R (J U S T)"
mode, only the first one is recorded.
● In order to ensure that the recording fits on the disc, this feature may
leave a slight non-recorded section at the end of the disc.
● There may be some noise and sound disturbance at the point on the
disc where the unit switches the mode.
pg. 31) procedure. Be
6 to fit the total recording time
A: 1st
B: 2nd
C: 3rd
D: 4 t h
E: 5th
A: 1st
B: 2nd
C: 3rd
D: 4 t h
E: Blank (20 min.)
Advanced Recording (VHS)
● Turn on the unit.
● Turn on the TV and select the AV mode.
● Slide the TV/DVD switch to DVD.
● Press VHS so that the VH S lamp lights up on the unit.
STANDBY / ON
S-VIDEO VIDEO AU D IO
VHS
C.RESET
DISPLAY
VHS DVD
VHS/DVD
VHS DU B BING
TV INPUT
CH +/–
REC
CH
DVD
DV IN