Edit From A Camcorder - JVC DR-M10SUC Instructions Manual

88
EN
Edit From A
Camcorder
A
If the camcorder has no S-VIDEO output connector:
Recorder
1 STANDBY/ON
AUDIO/VIDEO
OUT
Camcorder
Player
B
If the camcorder has an S-VIDEO output connector:
Recorder Recorder
1 STANDBY/ON
S-Video cable
(not supplied)
S-VIDEO
OUT
Camcorder
AUDIO OUT
Player
AUDIO/VIDEO input
REC MODE
F1 DV DV IN
S-VIDEO VIDEO L(MONO)-AUDIO-R
Audio/video cable
(supplied)
S-VIDEO input
AUDIO input
REC MODE
F1 DV DV IN
S-VIDEO VIDEO L(MONO)-AUDIO-R
Not connected
Audio/video cable (supplied)
You can use a camcorder as the source player and your
unit as the recording deck.
Slide the TV/CABLE/DBS/DVD switch to DVD.
A
Make connections.
A If the camcorder has no S-VIDEO output connector:
— connect the camcorder's AUDIO OUTPUT and
VIDEO OUT connectors to the unit's AUDIO and
VIDEO input connectors on the front panel.
B If the camcorder has an S-VIDEO output connector:
— connect the camcorder's AUDIO OUTPUT and
S-VIDEO OUT connectors to the unit's AUDIO and
S-VIDEO input connectors on the front panel.
When using a monaural camcorder, connect its AUDIO
OUTPUT connector to the AUDIO L input connector on your
unit.
B
Set the unit's input mode.
Press CH +/– to set the channel to "F-1".
When using S-VIDEO connector, set "FRONT AUX F-1" to
"S-VIDEO". ( pg. 98)
When using VIDEO connector, set "FRONT AUX F-1" to
"VIDEO". ( pg. 98)
C
Set the recording speed.
Press REC MODE repeatedly until the desired recording
speed appears.
D
Prepare the camcorder for dubbing.
Start playback on the camcorder slightly before the actual
point from where you wish to start dubbing.
E
Start dubbing.
Press and hold 7, then press 4 on the Remote, or press
7 on the unit.
F
Stop dubbing.
Press 8 on the unit, then stop playback on the
camcorder.
NOTES:
All necessary cables can be obtained from your dealer.
Refer to the camcorder's instruction manual for operating
procedure.
The quality of dubbed picture becomes poorer than that of the
original.
EDITING (cont.)