Operation Instruction Guide - LG LSRC 26915SW, LSRC 26912SW, LSRC 26925SW, LSRC 26923SW, LSRC 26940SW, LSRC 26940TT, LSRC 26941SW, LSRC 26941ST, LSRC 26915TT, LS User Manual

Operation Instruction Guide

Before making the connection to the refrigerator, be sure the refrigerator
power cord is not plugged into the wall outlet.
If your refrigerator does not
•
have a water filter, we
recommend installing one. If
your water supply has sand or
particles that could clog the
screen of the refrigerator's
water valve. Install the filter in
the water line near the
refrigerator.
1. Remove the plastic flexible
cap from the water valve.
2. Place the compression nut and
ferrule (sleeve) onto the end of
the tubing as shown.
3. Insert the end of the copper tubing into the connection as far as possible. While
holding the tubing, tighten the fitting.
Tighten any connections that leak.
Plug In the Refrigerator
Arrange the coil of copper tubing behind the refrigerator so it does not vibrate
against the back of the refrigerator or against the wall. Push the refrigerator
back to the wall.
Start the lcemaker
Set the icemaking stop switch to the ON position The icemaker will not begin
to operate until it reaches its operating temperature of 15 °F (-9 °C). It will then
begin operation automatically if the icemaking stop switch is in the ON
position.
The automatic icemaker makes 8 cubes at a time, 120/150 pieces per day.
But these quantities may vary according to circumstance, including ambient
temperature, door openings, freezer load.etc.
The Icemaker stops when the bin is full.
It is normal to hear a noise when ice drops into the bin.
•
"
Installation
"