LG LSC 26905TT User Manual
Sxs refrigerator
Hide thumbs
Also See for LSC 26905TT:
- Service manual (146 pages) ,
- User manual (31 pages) ,
- Owner's manual (29 pages)
Table of Contents
Advertisement
Advertisement
Table of Contents
Related Manuals for LG LSC 26905TT
Summary of Contents for LG LSC 26905TT
- Page 2 Table of Contents...
-
Page 3: Important Safety Instruction
Introduction Entry The model and serial numbers are found on the inner case or back of refrigerator compartment of this unit. These numbers are unique to this unit and not available to others. You should record requested information here and retain this guide as a permanent record of your purchase. -
Page 4: Identification Of Parts
DANGER: Risk of child entrapment. Before you throw away your old refrigerator or freezer: Take off the doors but leave the shelves in place so that children may not easily climb inside. The appliance is not intended for use by young children without supervision. -
Page 5: Where To Locate
2. Avoid placing the unit near heat sources, direct sunlight, or moisture. 3. To avoid vibrations, the appliance must be leveled. 4. Do not install this refrigerator in areas where the ambient temperature is below It will have an adverse effect on performance. -
Page 6: Door Removal
• After removing the door, take it into the kitchen where you are installing the refrigerator. Lay it down on a blanket and be careful to avoid damaging the water feed tube. 1) Loosen the hinge cover screws and remove the cover. -
Page 7: Door Replacement
Push the refrigerator sideways through the entrance door as shown in the right picture. Door replacement Mount the doors in the reverse order of removal after the refrigerator has been moved to the installation area. Feed water tube installation Automatic icemaker operation needs water pressure of 21.3~121psi(lb/inch is, a 7oz. -
Page 8: Water Connection Instruction Guide
1/4-inch nut driver 1/4-inch drill bit Hand drill or electric drill (properly grounded) Your refrigerator dealer has a kit available with a 1/4-inch saddle-type shut-off valve, • a union, and copper tubing. Before purchasing, make sure a saddle-type valve complies with your local plumbing codes. Do not use a piercing-type or 3/16-inch saddle valve which reduces water flow and clogs more easily. - Page 9 4. To determine the length of copper tubing you will need, measure from the connection on the lower left rear of the refrigerator to the water pipe. Add 7 feet (2.1m) to allow for moving refrigerator for cleaning. Use 1/4-inch O.D.
-
Page 10: Operation Instruction Guide
Tighten any connections that leak. Plug In the Refrigerator Arrange the coil of copper tubing behind the refrigerator so it does not vibrate against the back of the refrigerator or against the wall. Push the refrigerator back to the wall. - Page 11 The first ice and water may include particles or odor from the feed water pipe or feed water box. This is also necessary if the refrigerator has not been used for a long time. Never store beverage cans or other foods in ice storage bin for the purpose of rapid cooling.
-
Page 12: Height Adjustment
After leveling the The refrigerator doors will close smoothly by adjusting the height adjusting screw. If door height the doors do not close correctly, performance may be affected. Next 1. Wipe off all dust accumulated during shipping and clean your appliance thoroughly. -
Page 13: Adjusting The Temperatures And Functions
Operation Starting When your refrigerator is first installed, allow it to stabilize at normal operating temperatures for 2-3 hours prior to filling it with fresh or frozen foods. If operation is interrupted, wait 5 minutes before restarting. Adjusting The Temperatures and Functions... - Page 14 1. Buzzer sound mute Mode The buzzer sound is set to OFF. It activates by sounding the recognition sound of “Ding~” after pressing and holding “Express FRZ” button more than 5 seconds. It inactivates when resetting the mode power. 2. Display Power saving Mode It places display in standby mode until door is opened.
- Page 15 The actual inner temperature varies depending on the food status, as the indicated setting temperature is the target temperature, not actual temperature within refrigerator. Please adjust temperature as above after using refrigerator for minimum 2~3 days. You can select water or ice.
- Page 16 After the machine is powered again, crushed ice will be automatically selected. The unit is newly installed It takes about 12 hours for a newly installed refrigerator to make ice. Please select this function for prompt freezer. SELECT ”OFF➝...
-
Page 17: Door Open Warning
Operation Door open warning A warning tone will sound 3 times at thirty-second intervals if the refrigerator or freezer door is left open for more than sixty seconds. Please contact the local service center if warning tone continues to sound even after closing the door. - Page 18 Throw away the ice (about 20 pieces) and water (about 7 glasses) first made after refrigerator installation. This is also necessary when the refrigerator has not been used for a long time. Keep children away from the dispenser. Children may play with or damage the controls.
- Page 19 Operation Shelf The refrigerator compartment shelf is adjustable so that you can place it at a height according to space requirement of foods. Slide Shelf Pull the shelf ahead and take it out while lifting both front and rear part.
-
Page 20: Location Of Foods
Location of Foods (Refer to Identification of Parts) Store small foods such as bread, snacks, etc. Store various frozen foods such as meat, fish, ice cream, frozen snacks, etc. Store small packed frozen food. Temperature is likely to increase as door opens. -
Page 21: Storing Foods
• If you keep the refrigerator in a hot and humid place, frequent opening of the door or storing a lot of vegetables in it may cause condensation to form. Remove the... -
Page 22: How To Dismantle Parts
Remone cover by pressing upward on bottom and rotating outward Turn the bulb counterclockwise. Max. 40 W bulb for refrigerator is used and can be purchased at a service center. Seperate the lamp by pulling it out, and then remove the lamp. Max. 15 W bulb for refrigerator is used and can be purchased at a service center. - Page 23 To remove the lamp cover, press the protrusion under the lamp cover to the front and then pull the lamp cover out. Turn the bulb counterclockwise. Max. 40 W bulb for refrigerator is used and can be purchased at a service center.
-
Page 24: General Information
Care and Maintenance General Information During average length vacations, you will probably find it best to leave the refrigerator in operation. Place freezable items in freezer for longer life. When you plan to store the refrigerator, remove all food, disconnect the power cord, clean the interior thoroughly, and Block the doors open to prevent mold and mildew. -
Page 25: Troubleshooting
Call local electric company. This is normal. Larger, more efficient units run longer in these conditions. It is normal for the refrigerator to work longer under these conditions. It takes some hours for the refrigerator to cool down completely. - Page 26 Set the freezer or refrigerator control to a colder setting until the freezer or refrigerator temperature is satisfactory. Set the freezer or refrigerator control to a colder setting until the freezer or refrigerator temperature is satisfactory. Warm air enters the refrigerator/ freezer whenever the door is opened.
- Page 27 Refrigerator operates at higher pressures during the start of the ON cycle. Floor is uneven or weak. Refrigerator rocks on the floor when it is moved slightly. Items placed on the top of the refrigerator are vibrating. Dishes are vibrating on the shelves in the refrigerator.
- Page 28 Interior needs to be cleaned. Food with strong odor is in the refrigerator. Some containers and wrapping materials produce odors. Food package is keeping door open. Door was closed too hard, causing other door to open slightly. Refrigerator is not level. It rocks on the floor when it is moved slightly.
- Page 29 To Obtain Nearest Authorized Service Center Call 1-800-243-0000, push option #1, 24 hours a day, 7days per week. Please have your product type (Monitor, TV, VCR, MWO, Refrigerator) and ZIP code ready. Remove ice storage bin, and thaw and the contents. Clean bin, wipe dry and replace in proper position.