Operation Instruction Guide; Connect Tubing To Refrigerator; Turn Water On At Shutoff Valve - LG LSC27926ST Owner's Manual

Connect the Tubing
to the Refrigerator
Turn the Water On at
the Shutoff Valve
Automatic Ice maker
CAUTION
1 1

Operation Instruction Guide

Before making the connection to the refrigerator, be sure the refrigerator
power cord is not plugged into the wall outlet.
If your refrigerator does not
•
have a water filter, we
recommend installing one. If
your water supply has sand or
particles that could clog the
screen of the refrigerator's
water valve. Install the filter in
the water line near the
refrigerator.
1. Remove the plastic flexible
cap from the water valve.
2. Place the compression nut and
ferrule (sleeve) onto the end of
the tubing as shown.
3. Insert the end of the copper tubing into the connection as far as possible. While
holding the tubing, tighten the fitting.
Tighten any connections that leak.
Plug In the Refrigerator
Arrange the coil of copper tubing behind the refrigerator so it does not vibrate
against the back of the refrigerator or against the wall. Push the refrigerator
back to the wall.
Start the lcemaker
Set the icemaking stop switch to the ON position The icemaker will not begin
to operate until it reaches its operating temperature of 15 °F (-9 °C). It will then
begin operation automatically if the icemaking stop switch is in the ON
position.
The automatic icemaker makes 8 cubes at a time, 120/150 pieces per day.
But these quantities may vary according to circumstance, including ambient
temperature, door openings, freezer load etc.
The Icemaker stops when the bin is full.
NOTE
•
It takes about 12 hours for a newly installed refrigerator to make ice.
It is normal to hear a noise when ice drops into the bin.
•
- The first ice and water may include particles or odor from the feed water pipe or
feed water box. Throw away the ice.
This is also necessary if the refrigerator has not been used for a long time.
- Never store beverage cans or other foods in ice storage bin for the purpose of rapid
cooling. Such actions may damage the automatic ice maker.
- Never remove the icemaker cover.
- Shake the bin occasionally to cause the ice to settle.
- Ice may pile up just around the icemaker causing the icemaker to think that the ice
storage bin is full.
- If discolored ice is dispensed, contact an Authorized Service Center immediately.
Do not use the ice or water until the problem is corrected.
Tubi ng Clamp
1
1/4"
Compression
Nut
2
Ferrule
(sleeve)
Installation
Coil of Polyethylene or
1/4" Cooper Tubing
Refrigerator Connection