Operation Instruction Guide - LG LRSC26912SW User Manual

Connect the Tubing
to the Refrigerator
Turn the Water On at
the Shutoff Valve
Automatic Ice maker
Operation Instruction Guide
Before making the connection to the refrigerator, be sure the refrigerator
power cord is not plugged into the wall outlet.
• If your refrigerator does not
have a water filter,
we
Tubing_amp f
recommend installing one. If
your water supply has sand or
particles that could clog the
1/4" ssion _,
screen of the refrigerator's compre
water valve. Install the filter in
Nut
the water line near the
refrigerator.
Ferrule
1. Remove the plastic flexible
cap from the water valve.
Tighten any connections that leak.
• Plug In the Refrigerator
Arrange the coil of copper tubing behind the refrigerator so it does not vibrate
against the back of the refrigerator or against the wall. Push the refrigerator
back to the wall.
• Start the Icemaker
Set the icemaking stop switch to the ON position The icemaker will not begin
to operate until it reaches its operating temperature of 15 °F (-9 °C). It will then
begin operation automatically if the icemaking stop switch is in the ON
position.
• The automatic icemaker makes 8 cubes at a time, 120/150 pieces per day.
But these quantities may vary according to circumstance, including ambient
temperature, door openings, freezer load.etc.
• The Icemaker stops when the bin is full.
1/4"Tubing
2. Place the compression nut and
ferrule (sleeve) onto the end of Refrigerator Connection
the tubing as shown.
3. Insert the end of the copper tubing into the connection as far as possible. While
holding the tubing, tighten the fitting.