Operation Instruction Guide - LG LRSC21935TT User Manual

Connect the tubing to
the refrigerator
Turn the water on at
the shutoff valve
Automatic ice maker
All manuals and user guides at all-guides.com

Operation instruction guide

Before making the connection to the
refrigerator, be sure the refrigerator
power cord is not plugged into the wall
outlet.
1. Remove the plastic flexible cap from
the water valve.
2. Place the compression nut and ferrule
(sleeve) onto the end of the tubing as
shown.
3. Insert the end of the copper tubing into
the water valve connection as far as
possible. While holding the tubing,
tighten the fitting.
Tighten any connections that leak.
Plug In the Refrigerator
Arrange the coil of copper tubing so that it does not vibrate against the back of
the refrigerator or against the wall. Push the refrigerator back to the wall.
Start the lcemaker
Set the ice making stop switch to the ON position The icemaker will not begin
to operate until it reaches its operating temperature of 15 °F (-9 °C) or below. It
will then begin operation automatically if the ice making stop switch is in the
ON position.
The automatic ice maker can automatically make 8 pieces of ice cube at a time,
80-100 pieces a day.
But these quantities may be varied according to various conditions including
how many times the refrigerator door opens and closes.
Ice making stops when the ice storage bin is full.
NOTE
It is nomal that a noise is produced when ice made is dropped into the ice storage bin.
•
10
Installation
Copper tubing
(Provided)
Compression nut
(Provided)
Ferrule (sleeve)
Water valve