Setting The Ch Level - Sherwood RD-6505 Operating Instructions Manual

RD-6505(E)_ENG_100517_RD-6505(E)_ENG 2010-05-24 오전 9:59 페이지 36

SETTING THE CH LEVEL

■Note : Depending on the speaker settings ("N (No)"), some channels cannot be selected.
Adjusting the current channel level
• You can adjust the current channel levels as desired. These adjusted levels are just memorized into user's
memory("CAL"), not into preset memory ("REF 1", "REF 2")
• After adjusting each channel level with test tone, adjust the channel levels either according to the program sources or
to suit your tastes. (For details, refer to "Adjusting each channel level with test tone" on page 19.)
1.
Press the CURSOR UP(▲)/DOWN(▼) buttons
to select the desired channel.
Example) When selecting Dolby Digital source's LFE
DTS
DTS
2.
Press the CURSOR LEFT(◀)/RIGHT(▶)
buttons to adjust the level of the selected
channel or program source's LFE as desired.
• The LFE level can be adjusted within the range of -10 ~
0 dB and other channel levels within the range of -15 ~
+15 dB
• In general, we recommend the LFE level to be
adjusted to 0 dB.(However, the recommended LFE
level for some early DTS software is -10 dB.) If the
recommended levels seem too high, lower setting as
necessary.
3.
Repeat the above steps 1 and 2 to adjust each
channel level.
36
DTS