Setting The Ch Level Setup - Sherwood RD-705i Operating Instructions Manual

RD-705i(G)_ENG_101206_RD-705i(G)_ENG 2010-12-07 오전 10:25 페이지 53

SETTING THE CH LEVEL SETUP

CH LVL SETUP
■Note : Depending on the speaker settings ("NO", etc), some channels cannot be selected.
Adjusting the current channel level
• You can adjust the current channel levels as desired. These adjusted levels are just memorized into user's memory("CAL"),
not into preset memory ("REF 1", "REF 2")
• After adjusting each channel level with test tone, adjust the channel levels either according to the program sources or to suit
your tastes. (For details, refer to "Adjusting each channel level with test tone" on page 21.)
1.
Press the CURSOR UP(▲)/DOWN(▼) buttons
to select the desired channel.
Example: When selecting Dolby Digital source's LFE
CH
D D
MODE : CAL / REF 1 / REF 2
LEFT : 0 dB / -15 ~ + 15
CENTER : 0 dB / -15 ~ + 15
RIGHT : 0 dB / -15 ~ + 15
SURR R: 0 dB / -15 ~ + 15
SBACK R : 0 dB / -15 ~ + 15
SBACK L : 0 dB / -15 ~ + 15
SURR L : 0 dB / -15 ~ + 15
SUBW : 0 dB / -15 ~ + 15
DD : 0 dB / -10 ~ 0
DTS : 0 dB / -10 ~ 0
RETURN
AT
L V L S T E 3 0
U P
: 0 d B
2.
Press the CURSOR LEFT(◀)/RIGHT(▶)
buttons to adjust the level of the selected
channel or program source's LFE as desired.
• The LFE level can be adjusted within the range of -10 ~ 0
dB and other channel levels within the range of -15 ~ +15 dB
• In general, we recommend the LFE level to be adjusted to
0 dB.(However, the recommended LFE level for some
early DTS software is -10 dB.) If the recommended levels
seem too high, lower setting as necessary.
3.
Repeat the above steps 1 and 2 to adjust each
channel level.
53