Listening To Radio Broadcasts - Sherwood RD-6505 Operating Instructions Manual

RD-6505(E)_ENG_100517_RD-6505(E)_ENG 2010-05-24 오전 9:59 페이지 22

LISTENING TO RADIO BROADCASTS

Auto tuning
1.
Select the desired band.
• Each time this button is pressed, the band changes as
follows ;
→ FM ST → FM MONO → AM
("ST" lights up) ("ST" goes off)
• When FM stereo broadcasts are poor because of
weak broadcast signals, select the FM mono mode to
reduce the noise, then FM broadcasts are reproduced
in monaural sound.
2.
Press the TUNING UP(+)/DOWN(-) buttons for
more than 0.5 second.
• The tuner will now search until a station of sufficient
strength has been found. The display shows the
tuned frequency and "TUNE".
• If the station found is not the desired one, simply
repeat this operation.
• Weak stations are skipped during auto tuning.
Manual tuning
• Manual tuning is useful when you already know the
frequency of the desired station.
• After selecting the desired band, press the TUNING
UP(+) / DOWN(-) buttons repeatedly until the right
frequency has been reached.
Auto presetting
• Auto presetting function automatically searches for FM
stations only and store them in the memory.
• While listening to radio broadcasts, press and hold
down the ENTER(/MEMORY) button for more than 2
seconds.
• Then "AUTO MEM" flickers and this receiver starts
auto presetting.
• To stop auto presetting, press this button again.
• Up to 30 FM stations can be stored.
■Notes:
• FM stations of weak strength cannot be memorized.
• To memorize AM stations or weak stations, preform
"Manual presetting" procedure with using "Manual
tuning" operation.
22