Sherwood RD-6505 Operating Instructions Manual page 18

RD-6505(E)_ENG_100517_RD-6505(E)_ENG 2010-05-24 오전 9:59 페이지 18
When adjusting the sound parameters
• While playing digital signals from Dolby Digital or DTS program source or listening in Dolby Pro Logic II Music
mode, you can adjust their parameters for optimum surround effect.
1.
Press the SOUND PARAMETER button.
• Then "NIGHT : ~ " (or "PANO : ~ ") is displayed for
several seconds.
• If the parameter mode disappears, press this button
again.
2.
Press the CURSOR UP(▲)/DOWN(▼) buttons
to select the desired parameter.
• Each time these buttons are pressed, the parameter
mode changes as follows:
→ "NIGHT" ↔ "PANO" ↔ "C.WIDTH" ↔ "DIMEN" ←
(Night (Panorama
mode) mode)
• "NIGHT" can be selected only while playing digital
signals from Dolby Digital or DTS source.
• "PANO", "C.WIDTH" and "DIMEN" can be selected only
while listening in Dolby Pro Logic II Music mode.
(Center width (Dimension
control) control)
18
3.
Press the CURSOR LEFT(◀)/ RIGHT(▶)
buttons to adjust the selected parameter as
desired.
■When selecting the "NIGHT (Night mode)"
This function compresses the dynamic range of
previously specified parts of Dolby Digital or DTS sound
track (with extremely high volume) to minimize the
difference in volume between the specified and non-
specified parts. This makes it easy to hear all of the
sound track when watching movies at night at low
levels. The night mode can be set in 11 steps from 0.0
to 1.0 (default value : 0.0).
■Note : In some Dolby Digital or DTS softwares, the
night mode may not be valid.
■When selecting the "PANO (Panorama)" mode
This mode extends the front stereo image to include the
surround speakers for an exciting "wraparound" effect
with side wall imaging.
Select "OFF" or "ON"(default value: OFF).
■When selecting the "C. WIDTH (Center width)"
control
This adjusts the center image so it may be heard only
from the center speaker, only from the left/right
speakers as a phantom image, or from all three front
speakers to varying degrees.
The control can be set in 8 steps from 0 to 7(default
value : 3).
■When selecting the "DIMEN (Dimension)" control
This gradually adjusts the soundfield either towards the
front or towards the rear. The control can be set in 7
steps from -3 to +3 (default value : 0).
4.
Repeat the above steps 2 and 3 to adjust other
parameters.