Setting The Ch Level - Sherwood RD-5503 Operating Instructions Manual

SETTING THE CH LEVEL

Note : Depending on the speaker settings ("N (None or No)"), some channels cannot be selected.
Adjusting the current channel level
• You can adjust the current channel levels as desired. These adjusted levels are just memorized into user's memory("CAL"),
not into preset memory ("REF 1", "REF 2")
• After adjusting each channel level with test tone, adjust the channel levels either according to the program sources or to suit
your tastes. (For details, refer to "Adjusting each channel level with test tone" on page 17.)
1.
Press the CURSOR UP( )/DOWN( ) buttons to select the desired channel.
2.
Press the CURSOR LEFT( )/RIGHT( ) buttons to
adjust the level of the selected channel or program
source's LFE as desired.
• The LFE level can be adjusted within the range of -10 ~ 0
dB and other channel levels within the range of -15 ~ +15 dB
• In general, we recommend the LFE level to be adjusted to
0 dB. If the recommended levels seem too high, lower
setting as necessary.
Example) When selecting Dolby Digital source's LFE
3.
Repeat the above steps 1 and 2 to adjust each
channel level.
36