Garmin GNS 430 Pilot's Manual And Reference page 207

Invalid waypoint ident - An attempt was made
to create a user waypoint with an invalid name.
The GNS 430 does not allow spaces between
characters in the waypoint name.
MAIN processor requires service - The GNS
430 has detected a failure in the main system
processor. The GNS 430 is not usable and should
be taken to a Garmin dealer for service.
Memory battery low - The internal battery
that sustains user memory is low and should be
replaced by a Garmin dealer as soon as possible.
Failure to do so may result in loss of stored
data, including flight plans, user waypoints, unit
settings, and satellite data.
Near airspace -- less than 2 nm - The GPS-
calculated position is within 2 nm of a special
use airspace boundary, but the aircraft is not
projected to enter the airspace. This message is
automatically disabled within 30 nm of an arrival
airport, when an approach is loaded.
Need altitude - display position page - The
GPS receiver needs altitude input in order to
start and/or continue 2D navigation. Select the
Position Page and verify the altitude reading. If
the altitude is in error by more than 500 feet,
enter the current altitude as accurately as possible.
An inaccurate altitude directly translate into
inaccurate position information.
No altitude input is being received - No
altitude data is being received from RS-232
(Serializer: Icarus, Rosetta or Shadin) or grey code
inputs. If the problem persists, contact a Garmin
dealer and check the installation and installation
settings. When this message occurs, no pilot
action is required if enough satellites are available
for a 3D position fix (provided no RAIM warnings
are present). However, if only a 2D position fix
is possible, the pilot should maintain the GPS
altitude within 1,000 feet of pressure altitude by
entering the altitude on the Position Page.
No basemap data available - The GNS 430 has
detected a failure in the built-in basemap (land
data) memory. Land data does not appear on
the Map Page. Other unit functions continue to
work normally, however the GNS 430 should be
taken to a Garmin dealer for service at the earliest
convenience.
Non-WGS84 wpt navigation - The active
'to' and/or 'from' waypoints are based upon a
map datum other than WGS 84 and cannot
be converted from that map datum to WGS
84. Expect some error in the position of the
waypoint(s) and cross-check with an alternate
means of navigation.
Not receiving input data on 429 Channel 1
- No data has been received on the ARINC 429
channel 1 connection for a period exceeding five
seconds. If the problem persists, the installation
should be checked by a Garmin dealer.
Not receiving input data on 429 Channel 2
- No data has been received on the ARINC 429
channel 2 connection for a period exceeding five
seconds. If the problem persists, the installation
should be checked by a Garmin dealer.
GNS 430 Pilot's Guide and Reference
SECTION 13 – MESSAGES,
ABBREVIATIONS, & NAV TERMS
13-5