Winnebago Suncruiser Owner's Manual page 103

2. Press ON/OFF button, set water temperature
to WARM, then press START. Let machine
fill until the drum turns (this could take up to
1 to 2 minutes).
3. Press ON/OFF button to turn power OFF.
4. Advance Cycle Selector to "B".
5. Press ON/OFF button, then press START.
6. After letting antifreeze drain completely from
drum, press the ON/OFF button to turn power
OFF. Finished.
To use Washer/Dryer again after seasonal
storage:
1. Reconnect water inlet hoses to corresponding
HOT/COLD faucets. Turn faucets ON.
NOTE: Check water inlet hoses and pump
periodically (see manufacturer's user
guide for further information).
2. Plug Washer/Dryer into electrical outlet (or
reconnect power).
3. With Washer/Dryer power OFF, pour 1/2
TBSP. of powder detergent (or liquid
equivalent) into "Compartment 2" inside
Dispenser Drawer.
4. Advance Cycle Selector to "Position 4".
5. Press ON/OFF button, then press START.
6. Allow machine to run through the complete
cycle to clean out any remaining antifreeze.
Finished.
SECTION 7 –
PLUMBING
7-21