Table of Contents
Advertisement
4 / CARING FOR AND CLEANING YOUR APPLIANCE
Warning
Always unplug the hood before cleaning it or performing other maintenance acts.
Regular maintenance of your appliance is a guarantee of proper functioning, good perform-
ance and durability.
Warning
Failure to respect the guidelines for cleaning the appliance and filters may cause fires.
Please carefully adhere to the maintenance recommendations.
•
CLEANING
TRIDGES
They must be cleaned after approximately 30
hours of use or at least once a month. Use a
brush, hot water and mild detergent.
Rinse and dry them thoroughly before returning
them to the hood.
•Dismantling the filter cartridge (fig.1)
— Replace it after approximately 120 hours of
use.
— Remove the filter cartridge by unclipping it (fig.
1).
•
CHANGING THE CARBON FILTER
(not supplied)
The carbon filter should be replaced after
approximately 120 hours of use.
— Unclip the filter cartridge to remove it (A.fig.
1).
— Remove the carbon filter or the plastic protec-
tion grille (B.fig.1)
— Inset the new carbon filter.
If you do not intend to use a carbon filter, leave
the plastic protection grille in place.
CLEANING THE OUTER SURFACES
•
To clean the outside of your hood, use soapy water, but do not use abrasive creams or scrubbing
sponges.
CHANGING THE LIGHT BULB
•
M M o o d d e e l l w w i i t t h h h h a a l l o o g g e e n n b b u u l l b b
— Remove the lighting port (fig. 2).
— Change the G4-20W-12V halogen bulb.
— Replace the bulb by repeating these steps
in reverse order.
THE
FILTER
CAR-
fig. 1
29
EN
fig. 2
Advertisement
Table of Contents
