BIG ASS FANS Haiku 60 Installation Manual page 13

O ptio n al Han ger P lat e
If mounting the fan to a concrete ceiling and a ceiling hook is not located at the fan site, a hanger
plate with a safety cable hook should be installed. The concrete mounting method is not available in
North America.
The safety cable must be installed with an anchor hook if mounting the fan with the hanger
plate accessory.
Step 1. Installing anchor bolts
Drill three 012 mm to 12.5 mm holes in the pattern shown below. The hole depth should not exceed
35 mm to 40 mm.
Remove any dust from the holes. Insert the anchor bolts into the holes. Strike the heads of the anchor
bolts with a hammer, ensuring the bolt sleeves are flush with the ceiling surface.
Ø12–12.5 mm
35 mm
Step 2. Securing the hanger plate
Position the hanger plate on the anchor bolts. Ensure all anchor bolts are fully tightened to expand
and lock the anchors.
Step 3. Installing the safety anchor hook
Drill a 8–8.5 mm hole adjacent to the ceiling plate. The hole depth
should not exceed 35–40 mm. Remove any dust from the hole, and
then insert the anchor hook and fully tighten.
Step 4. Hanging the fan
Raise the fan to ceiling hook, and then loosely attach it by securing the extension tube bracket to the
ceiling hook with the mounting hardware as shown on the previous page.
Be careful not to drop any hardware in the wiring cover during installation!
Step 5. Securing the safety cable
Loop the safety cable around the ceiling hook and through the anchor hook. Secure it with the locking
pin.
Proceed to Step 7. Wiring the fan on the following page.
®
HAIKU by Big Ass Fans
35 mm
Concrete Ceiling
Anchor Hook
9