Xll Panel Setup; Sim Card Installation; Xll Assembly - Videofied XL200L Installation Manual

1. XLL Panel Setup

1.1 XLL Panel Setup
Open the box and remove the cardboard
mounting template sitting on top. Place the
template on wall with the arrow pointing upward.
Mark the 5 screw points on the wall and drill pilot
holes for wall anchors. Install wall anchors, then
attach base of control panel to wall.
XLL panel is provided with a reinforcement brace
kit including 4 velco straps. Insert the 4 straps in
the back casing, then mount the casing on the
wall. (The EN50131 standard requires the installation
of this brace kit).
A screw must be used in the tamper protection
hole for the panel wall tamper to function
correctly.
Insert the Alkaline D type batteries as shown;
ensuring the polarity matches the labeling on the
inside of the battery cover.

1.2 SIM Card Installation

Before removing the front cover from its box,
Put the SIM card on the plastic base (Take care
to respect the right direction).
DO NOT insert or remove the SIM card while the
panel is powered.

1.3 XLL Assembly

Connect the panel's face to its base by carefully
placing the hinges on it.
2 locking clips are provided to strengthen
the hinges: position each locking clip before
locking them completely (The EN50131 standard
requires the installation of these locking clips).
Locking clips location
www.videofied.com
I N S T A L L A T I O N
Tamper bracket hole
Mandatory to trigger tamper alarm.
M A N U A L
Bracket holes
4