Arming And Siren Mode Configuration - Videofied XL200L Installation Manual

3. XLL Features Guide

3.3 Arming and Siren Mode Configuration

•
Use to go to menu :
CONFIGURATION (LEVEL 4) > SPECIAL ARMING MODES > FULL ARM, SP1 or SP2
Use direction arrows to select the arming mode you want to modify and
•
There is 3 different arming modes :
FULL ARM : Arming of all areas and all devices. Use a badge or a user code and press
key on the CMA keypad.
SP1 : Partial Arming (1) is enabled by entering the user code and pressing
keypad or on the remote keyfob RC.
SP2 : Partial Arming (2) is enabled by pressing the
keyfob RC.
For each arming mode, it is possible to specify how each of the 4 areas will be armed and how the system will behave during an alarm.
Areas : 1 2 3 4
State : A A A A
A Armed
D Disarmed
Perimeter
P
(by default : all opening contacts*)
External
E
(by default : all opening contacts
with external access*)
* You can set your devices as : External, Perimeter, ou External +Perimeter. Please go to the menu:
CONFIGURATION (LVL 4) -> AREAS AND DEVICES -> DEVICES -> DEVICES CONFIGURATION -> DEVICE TYPE
I N S T A L L A T I O N
OK / YES
key on a XMA/XMB keypad,
Each time you press the corresponding number, the system will toggle the arming
state for the respective area.
Press OK / YES after this configuration step. The system will then display what siren mode
will be in effect for this special profile. Select the siren mode using the direction arrows then
press OK / YES .
Siren
Delay Beeps
Silent
Without Siren
www.videofied.com
.
OK / on the XMA/XMB keypad or the
on the XMA/XMB keypad, the
on a CMA keypad, or
Immediate triggering of all sirens
Entry/Exit delay beeps, then triggering of all sirens
No Sirens, No Beeps
Beeps on the keypad only
M A N U A L
YES
key on the CMA
on the remote
14