Maytag LD10D2 Service Manual page 36

Operation—LD10MP and LD10MPS
User Options
Follow the instructions below to customized the
microwave oven's operation. End-of-cycle signal,
maximum heating time and other options can be changed
to meeting your cooking needs.
1. Open oven door.
• If door is closed or RESET pad is pressed before
finishing programming sequence, oven exits
programming mode.
2. Press and hold pad 2 for approximately 5 seconds.
• After 5 seconds, signal sounds. Display shows
"OPTION".
Numbered Pads
1
End of Cycle Beep
2
Speaker Volume
3
Key Beep
4
Keyboard Enable
Window
5
Add Time during
Heating
6
Reset Door Open
7
Maximum Heating
Time
8
Manual Operation
9
Double Digit
A–6
Display Options ( ) = Factory Setting
OP:10 3 second continuous beep
OP:11
(Continuous Beep until door is opened)
OP:12 5 beeps bursts until door is opened
OP:20 Eliminates beep
OP:21 Sets volume to low; 60-70dB
OP:22 Sets volume to medium; 70-80dB
OP:23 (Sets volume to high; 80-90dB)
OP:30 Prevents signal when pad is pressed.
OP:31
(Allows signal when pad is pressed.)
OP:40
(30 seconds after oven door is opened, keyboard disabled)
OP:41 2 minutes after oven door is opened, keyboard disabled
OP:50 (Prevents adding heating time while oven is heating.)
OP:51 Allows adding heating time while oven is heating.
OP:60 (Cancels heating time count down after door is opened during
cycle.)
Allows oven to resume heating time countdown after door is
OP:61
opened during cycle.
OP:70 Allows 10 minutes of heating time. (If more than 10 min. is
programmed in this setting, unit will beep 3 times and no
OP:71
programming will occur.)
(Allows 60 minutes of heating time.)
OP:80 Allows use of preprogrammed pads only.
OP:81
(Allows use of manual time entry and preprogrammed pads.)
OP:90
(Allows use of double digit only.)
OP:91 Allows use of single digit only.
16023053 Rev. 0
3. Press number pad that matches desired option.
• "OP" represents optional program mode, first
number represents option number and second
number represents functions currently selected for
option.
4. Press number pad to change option setting.
5. Press START pad to save changes.
• Repeat steps 3-5 to change additional options.
6. Press STOP/RESET pad or close oven door to exit
programming mode.
©2004 Maytag Appliances Company