Description - Hilti TE 60 Operating Instructions Manual

Obligation signs
en Wear eye Wear a hard
protection
Wear
breathing
protection
Symbols
Read the Return waste
operating material for
instructions recycling.
before use
Chisel Volts
position
adjustment

2 Description

2.1 Use of the product as directed
The power tool is an electrically-powered combihammer with pneumatic hammering mechanism. The ATC (Active
Torque Control) feature incorporated in the TE 60‑ATC provides greater working comfort for the user when drilling.
The tool is designed for drilling in concrete, masonry, metal and wood and can also be used for chiseling.
The power tool is equipped with electronic overload protection. If the power tool is overloaded for a continuous period,
motor speed will be reduced automatically and, if necessary, the motor may be stopped completely. When the control
switch is released and then pressed again, the motor immediately regains full power. When restarting, care should
thus be taken to ensure that the power tool is held securely with both hands.
Under certain conditions, the power tool is suitable for use for mixing (see "Tools, accessories" and "Operation").
The power tool is designed for professional use and may be operated, serviced and maintained only by trained,
authorized personnel. This personnel must be informed of any special hazards that may be encountered. The power
tool and its ancillary equipment may present hazards when used incorrectly by untrained personnel or when used not
as directed.
Working on materials hazardous to the health (e.g. asbestos) is not permissible.
The working environment may be as follows: construction site, workshop, renovation, conversion or new construction.
The power tool may be used only in a dry environment.
Take the influences of the surrounding area into account. Do not use the power tool or appliance where there is a risk
of fire or explosion.
The power tool may be operated only when connected to a power supply providing a voltage and frequency in
compliance with the information given on its type identification plate.
Observe the information printed in the operating instructions concerning operation, care and maintenance.
To avoid the risk of injury, use only genuine Hilti accessories and insert tools.
Modification of the power tool or tampering with its parts is not permissible.
2
Wear ear
hat protection
Hammer
drilling
Amps
Hertz
Wear
protective
gloves
Diameter
Location of identification data on the power tool
The type designation can be found on the type identifica-
tion plate and the serial number on the side of the motor
housing. Make a note of this data in your operating in-
structions and always refer to it when making an enquiry
to your Hilti representative or service department.
Chiseling
Type:
Generation: 03
Serial no.:
Alternating
current
Rated speed Revolutions
under no per minute
load
Double Equipped
insulated with theft
protection
system
Revolutions
per minute
Lock symbol