PURE NETWORKING 10/100 MINI PRINT SERVERS USERS' MANUAL
:sd=/var/spool/lpd/pserverd:\
:mx#0:
Lines should be indented with tabs. More than one printer name can be used, with
variants separated by vertical bars (name1|name2).
The rm=entry should correspond to the IP address you have assigned to the print
server. You can also use a host name if you have assigned one in the /etc/hosts file.
The sd=entry should correspond to the spool directory you created in the previous
step.
The rp=entry should correspond to the remote printer's port name. The values
should be lpt1, lpt2, or lpt3, depending on the printer port.
The print server should now be available for printing from your UNIX host.
7.5 Print a Test Page
To print to the print server, type in the lpr command:
lpr -Pprinter-name file ...
or, type in the lp command on the SCO Open Server:
lp —d printer-name file ...
Printer-name is one of the names for the printer in the /etc/printcap file,
which you created in the previous step.
Consult your system documentation for more information about printer
configuration and administration and about lpr and other printing commands.
74